Development of Dynamic Asperity Models to Predict Surface Fault Displacement Caused by Earthquakes.

Autor: Dalguer, L. A., Wu, H., Matsumoto, Y., Irikura, K., Takahama, T., Tonagi, M.
Předmět:
Zdroj: Pure & Applied Geophysics; May2020, Vol. 177 Issue 5, p1983-2006, 24p
Abstrakt: Asperity models for ground motion prediction is widely used in Japan. Here we expand the application of these asperity models to predict fault displacement caused by surface rupture. The proposed approach is rather simple and practical for the use in fault displacement hazard analysis in nuclear installations and other critical infrastructures, as it is the emphasis of the current topical issue. The proposed method mainly consists of two steps. The first step consists in the characterization of asperities at the seismogenic zone based on the kinematic asperity source model following Irikura's recipe (Irikura and Miyake in Pure Applied Geophysics, 168:85–104, 2011) for strong ground motion prediction. Since the kinematic model does not take into account surface rupture mechanism, this first step assumes that the fault is buried, and then by trial and error procedure the stress drop on the asperities are estimated, so that the average slip at each asperity be consistent with the ones from the kinematic model. At this stage, the dynamic model predicts strong ground motion consistent with those from the kinematic model. In the second step, the surface rupture is included by calibrating the shallow layer (SL) with stress drop, strength excess and critical slip distance, so that the final fault displacement along the fault be consistent with observations. The 2010 Mw 7.0 Darfield (New Zealand) earthquake is used to test the proposed method. Surface-rupturing was observed in several sites along the main fault reaching values of fault displacement larger than 5 m. The main fault of this earthquake is strike-slip, almost vertical. Therefore, a simplified planar fault asperity model to capture the main features of the fault displacement is assumed. The fault dimensions are assumed to have a length of 60 km and a width of 24 km with three asperities. The preferred model of the first step predicts average slip for each asperity of 2.7, 2.7, and 2 m corresponding, respectively, to stress drops of 6.0 MPa, 8.5 MPa, and 7.0 MPa. In the second step, the surface rupture is calibrated assuming a SL zone of 3 km depth. We found that negative stress drop is not necessary in the SL, because this strongly inhibits surface rupturing. Our preferred model produces fault displacement distribution closer to the observed ones, but average slip at each asperity increases to 3.4 m, 3.2 and 2.8 m. This increase in average slip is due to the contribution of surface rupturing. Ground motion differences between fault-surface rupturing and buried models are negligible, except at the very near-source. These differences are attributed to the SL rupture that mainly affect the ground motion at the very near-source. Overall, our simple asperity model captures the main features of the observed fault displacement and near-source ground motion, proving that the proposed simple and practical two step-procedure provides meaningful estimate of fault displacement and near-source ground motion consistent with observations, as such, this method has the potential to be used in practical fault displacement hazard analysis. [ABSTRACT FROM AUTHOR]
Databáze: Complementary Index