Autor: |
Pu, N., Nishitani, T., Isobe, M., Ogawa, K., Kawase, H., Tanaka, T., Li, S. Y., Yoshihashi, S., Uritani, A. |
Předmět: |
|
Zdroj: |
Review of Scientific Instruments; 2017, Vol. 88 Issue 11, p113302-1-113302-7, 7p, 3 Diagrams, 2 Charts, 4 Graphs |
Abstrakt: |
In situ calibration of the neutron activation system on the Large Helical Device (LHD) was performed by using an intense 252Cf neutron source. To simulate a ring-shaped neutron source, we installed a railway inside the LHD vacuum vessel and made a train loaded with the 252Cf source run along a typical magnetic axis position. Three activation capsules loaded with thirty pieces of indium foils stacked with total mass of approximately 18 g were prepared. Each capsule was irradiated over 15 h while the train was circulating. The activation response coefficient (9.4 ± 1.2) x 10-8 of 115 In(n, n')115mIn reaction obtained from the experiment is in good agreement with results from three-dimensional neutron transport calculations using the Monte Carlo neutron transport simulation code 6. The activation response coefficients of 2.45 MeV birth neutron and secondary 14.1 MeV neutron from deuterium plasma were evaluated from the activation response coefficient obtained in this calibration experiment with results from three-dimensional neutron calculations using the Monte Carlo neutron transport simulation code 6. [ABSTRACT FROM AUTHOR] |
Databáze: |
Complementary Index |
Externí odkaz: |
|