| Autor: |
Mogheyse, Amir Hamze, MiarNaimi, Hossein |
| Předmět: |
|
| Zdroj: |
IET Microwaves, Antennas & Propagation (Wiley-Blackwell); 2017, Vol. 11 Issue 12, p1782-1790, 9p |
| Abstrakt: |
In this study, a new technique is introduced for full power combining in distributed amplifiers which contain multiplicative gain stages. Produced powers from middle stages of multiplicative structures are always wasted in terminating resistors. This study shows that an electrical funnel can be used to combine all produced powers from all stages. To do so, two configurations are considered to terminate middle stages with transistors. It is shown how a typical distributed amplifier can be converted to a two-dimensional distributed amplifier (2D-DA). Analytical expressions for gain calculation are also presented. All inductors and connections of 2D-DA are simulated by advanced design system (ADS) electromagnetic simulator with TSMC 0.18 CMOS layout specifications. Post-layout simulation results show the trueness of the presented relations. The designed 2DDA shows 17.4 dB gain along 0.7-25.7 GHz bandwidth by consuming 75.2 mW DC power. More than 3.9 dBm output power at 1 dB output compression point (OP1dB) is achieved and the noise figure of the 2D-DA is between 3.6 and 6.4 dB. Using 2D-DA, produced powers from middle stages participate in the outgoing power. This helps to improve gain bandwidth (GBW), power added efficiency (PAE) and OP1dB by 84.3, 143 and 86%. [ABSTRACT FROM AUTHOR] |
| Databáze: |
Complementary Index |
| Externí odkaz: |
|
Plný text