| Autor: |
Węgrzyniak, Adam, Jarczewski, Sebastian, Węgrzynowicz, Adam, Michorczyk, Barbara, Kuśtrowski, Piotr, Michorczyk, Piotr |
| Předmět: |
|
| Zdroj: |
Nanomaterials (2079-4991); Sep2017, Vol. 7 Issue 9, p249, 19p |
| Abstrakt: |
Mesoporous alumina with narrow pore size distribution centered in the range of 4.4-5.0 nm and with a specific surface area as high as 270 m²g-1 was prepared via the nanocasting approach using a CMK-3 carbon replica as a hard template. Based on this support, a series of catalysts containing 1, 5, 10, 20 and 30 wt % of chromium was prepared by incipient wetness impregnation, characterized, and studied in the dehydrogenation of propane to propene (PDH). Cr species in three oxidation states--Cr(III), Cr(V) and Cr(VI)--were found on the oxidized surface of the catalysts. The concentration of these species varied with the total Cr loading. Temperature-programmed reduction (H2-TPR) and UV-Vis diffuse reflectance spectroscopy (UV-Vis-DRS) studies revealed that Cr(VI) species dominated at the lowest Cr content. An increase in the Cr loading resulted in an appearance of an increasing amount of Cr(III) oxide. UV-Vis-DRS measurements performed in situ during the PDH process showed that at the beginning of the catalytic test Cr(VI) species were reduced to Cr(III) redox species. A crucial role of the redox species in the PDH process over the catalysts with the low Cr content was confirmed. The stability test for the catalyst containing 20 wt % of Cr showed that this sample exhibited the reproducible catalytic performance after the first four regeneration-dehydrogenation cycles. Moreover, this catalyst had higher resistance on deactivation during the PDH process as compared to the reference catalyst with the same Cr loading, but was supported on commercially available alumina. [ABSTRACT FROM AUTHOR] |
| Databáze: |
Complementary Index |
| Externí odkaz: |
|
