| Autor: |
Jablonski, Szymon, Czuba, Krzysztof, Ludwig, Frank, Schlarb, Holger |
| Předmět: |
|
| Zdroj: |
IEEE Transactions on Nuclear Science; 6/10/2015 Part 2, Vol. 62 Issue 3b, p1142-1148, 7p |
| Abstrakt: |
In modern particle accelerators, radio frequency (RF) phase detectors have to fulfill high demands on stability and accuracy to meet the goals of state-of-the-art synchronization systems. Especially challenging are those cases where the RF signal phase shift accuracy must be measured with fs accuracy for several hours over the full 2 \pi phase detection range. In these cases special measures on the component’s nonlinearities and RF channel isolation have to be taken. The long-term stability of the phase detector is mostly affected by temperature and humidity variations. To meet the synchronization goals, we have built a phase detector that incorporates a high-speed dual analog-to-digital converter (ADC) with a special circuit for continuous phase drift calibration. In the calibration circuit we successfully combined the RF signal with an RF calibration signal (second tone) to compensate common phase drift that occurs in the microstrip lines, the RF transformers, and the ADC. The second-tone RF signals are directly converted to the digital domain by the fast ADC and, based on signal processing in the field-programmable gate array, are used to calculate the RF signal phase shift correction caused by detector drifts. In this paper, potential error sources of the analog and the digital part of the so-called two-tone calibration technique that limit the phase detector precision are discussed. Finally, the experimental results are presented showing a long-term phase measurement stability better than 0.01\ ^\circ \ pk-\ pk evaluated at an RF frequency of 1.3 GHz over a few days. [ABSTRACT FROM PUBLISHER] |
| Databáze: |
Complementary Index |
| Externí odkaz: |
|
