| Autor: |
Kozub B; Department of Materials Engineering, Faculty of Material Engineering and Physics, Cracow University of Technology, 37 Jana Pawła II Street, 31-864 Cracow, Poland., Sitarz M; Chair of Building Materials Engineering, Faculty of Civil Engineering, Cracow University of Technology, 24 Warszawska Street, 31-155 Cracow, Poland., Gądek S; Department of Materials Engineering, Faculty of Material Engineering and Physics, Cracow University of Technology, 37 Jana Pawła II Street, 31-864 Cracow, Poland., Ziejewska C; Department of Applied Computer Science, Faculty of Mechanical Engineering, Cracow University of Technology, Al. Jana Pawła II 37, 31-864 Cracow, Poland., Mróz K; Chair of Building Materials Engineering, Faculty of Civil Engineering, Cracow University of Technology, 24 Warszawska Street, 31-155 Cracow, Poland., Hager I; Chair of Building Materials Engineering, Faculty of Civil Engineering, Cracow University of Technology, 24 Warszawska Street, 31-155 Cracow, Poland. |
| Abstrakt: |
Additive manufacturing using cement has evolved rapidly in recent decades, revolutionizing the construction industry. This technology automates building structures through computer-aided design, offering benefits such as reduced material waste, optimized material distribution, and the ability to use composite materials. This paper aims to examine the potential of using copper-slag-based geopolymers in 3D printing. Geopolymers have gained popularity as an alternative and more energy-efficient material to traditional building materials, while copper slag allows for reducing and managing mining industry waste. Moreover, samples formed in molds based on the same material were produced to evaluate the method of manufacturing on the mechanical properties of geopolymers. This paper presents an evaluation of the mechanical properties including the compressive, flexural, and shear strength of the layered material. It reveals promising results, with strength development mainly observed within the first 14 days. The results show that the compressive strength after 28 days of curing is 46.4 MP and 42.1 MPa for formed and printed samples, respectively. Furthermore, the average bending strength value ranges between 7.4 MPa and 7.8 MPa, regardless of the bending direction and forming method. The obtained results show that printed geopolymers demonstrate adequate layer bonding, confirming the profitability of the 3D printing technology. This research confirms that 3D printing technology enables the use of geopolymer binder materials based on copper slag, which opens the door to sustainable alternatives in construction practices. |
