Experimental analysis of a solar air heater using waste mild steel chips as a sensible heat storage material.

Autor: Das H; Department of Mechanical Engineering, School of Engineering, Tezpur University, Tezpur, India. sdharjyotidas@gmail.com., Dutta P; Department of Mechanical Engineering, School of Engineering, Tezpur University, Tezpur, India., Dutta PP; Department of Mechanical Engineering, School of Engineering, Tezpur University, Tezpur, India., Choudhury PK; Department of Energy, School of Engineering, Tezpur University, Tezpur, India.
Jazyk: angličtina
Zdroj: Environmental science and pollution research international [Environ Sci Pollut Res Int] 2024 Nov 04. Date of Electronic Publication: 2024 Nov 04.
DOI: 10.1007/s11356-024-35415-y
Abstrakt: Heat storage materials improve the utility of solar air heaters (SAHs) after sunset. This study investigates an improved solar air heater (SAH) performance with baffles and waste mild steel chips as sensible heat storage (SHS) materials. Comparative experimental natural convection heat transfer studies were performed with four different improved air heater setups under similar solar radiation conditions. These setups consist of a flat collector plate (I), a baffled plate collector (II), a flat plate collector with SHS (III) and a baffled plate collector with SHS (IV) respectively. Setups I, II, III and IV were obtained by modifying the same air heater enclosure and each experiment was replicated for three similar sunny days. During the periods, the solar radiation varied in the range of 556-934 W/m 2 . The maximum thermal efficiencies found for setups I, II, III and IV were 18.76%, 22.40%, 27.21% and 28.22% respectively under natural convection. The highest average useful energy rate was produced by setup IV, followed by setups III, II and I. After sunset, setups III and IV were able to deliver warm air for an extended period of 1 h, 18 min and 1 h, 42 min, respectively. It was found that setups III and IV had sensible thermal energy storage reserves of 0.38 kJ and 0.53 kJ, respectively. The storage efficiencies found for setups III and IV were 60.25% and 70.89%, respectively. Among the four setups, setup IV boasts the most economical energy cost at 1.39 ₹/kWh and having the least payback period of 1 year 4 months. As a result, the employment of baffles and waste mild steel chips as SHS in a flat plate SAH not only presents a method for harvesting waste for efficient heat retention, but it also effectively uses solar energy for beneficial uses.
(© 2024. The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.)
Databáze: MEDLINE
Externí odkaz: