| Autor: |
Akhtarian S; Department of Mechanical Engineering, York University, Toronto, ON M3J 1P3, Canada., Kaur Brar S; Department of Civil Engineering, York University, Toronto, ON M3J 1P3, Canada., Rezai P; Department of Mechanical Engineering, York University, Toronto, ON M3J 1P3, Canada. |
| Jazyk: |
angličtina |
| Zdroj: |
Biosensors [Biosensors (Basel)] 2024 Sep 18; Vol. 14 (9). Date of Electronic Publication: 2024 Sep 18. |
| DOI: |
10.3390/bios14090445 |
| Abstrakt: |
The rapid and sensitive detection of bacterial contaminants using low-cost and portable point-of-need (PoN) biosensors has gained significant interest in water quality monitoring. Cell-imprinted polymers (CIPs) are emerging as effective and inexpensive materials for bacterial detection as they provide specific binding sites designed to capture whole bacterial cells, especially when integrated into PoN microfluidic devices. However, improving the sensitivity and detection limits of these sensors remains challenging. In this study, we integrated CIP-functionalized stainless steel microwires (CIP-MWs) into a microfluidic device for the impedimetric detection of E. coli bacteria. The sensor featured two parallel microchannels with three-electrode configurations that allowed simultaneous control and electrochemical impedance spectroscopy (EIS) measurements. A CIP-MW and a non-imprinted polymer (NIP)-MW suspended perpendicular to the microchannels served as the working electrodes in the test and control channels, respectively. Electrochemical spectra were fitted with equivalent electrical circuits, and the charge transfer resistances of both cells were measured before and after incubation with target bacteria. The charge transfer resistance of the CIP-MWs after 30 min of incubation with bacteria was increased. By normalizing the change in charge transfer resistance and analyzing the dose-response curve for bacterial concentrations ranging from 0 to 10 7 CFU/mL, we determined the limits of detection and quantification as 2 × 10 2 CFU/mL and 1.4 × 10 4 CFU/mL, respectively. The sensor demonstrated a dynamic range of 10 2 to 10 7 CFU/mL, where bacterial counts were statistically distinguishable. The proposed sensor offers a sensitive, cost-effective, durable, and rapid solution for on-site identification of waterborne pathogens. |
| Databáze: |
MEDLINE |
| Externí odkaz: |
|
