Air-water interfacial and foaming properties of nanoparticles based on commercial and lab-scale isolated maize (Zea mays L.) zein.

Autor: Kaczynska K; Laboratory of Food Chemistry and Biochemistry, and Leuven Food Science and Nutrition Research Centre (LFoRCe), KU Leuven, Kasteelpark Arenberg 20, B-3001 Leuven, Belgium. Electronic address: katarzyna.kaczynska@kuleuven.be., Wouters AGB; Laboratory of Food Chemistry and Biochemistry, and Leuven Food Science and Nutrition Research Centre (LFoRCe), KU Leuven, Kasteelpark Arenberg 20, B-3001 Leuven, Belgium. Electronic address: arno.wouters@kuleuven.be., Delcour JA; Laboratory of Food Chemistry and Biochemistry, and Leuven Food Science and Nutrition Research Centre (LFoRCe), KU Leuven, Kasteelpark Arenberg 20, B-3001 Leuven, Belgium. Electronic address: jan.delcour@kuleuven.be.
Jazyk: angličtina
Zdroj: Food research international (Ottawa, Ont.) [Food Res Int] 2024 Nov; Vol. 195, pp. 114977. Date of Electronic Publication: 2024 Aug 23.
DOI: 10.1016/j.foodres.2024.114977
Abstrakt: Maize zein based nanoparticles (ZNPs) can have applications as food dispersion stabilizers. It has not been documented to what extent the used zein isolation method and conditions thereof impact the structure and functionality of nanoparticles (NPs) based thereupon. Here, zein extracted from maize flour on lab scale (LS-zein) was compared with a commercial zein powder (CS-zein). On a dry matter basis, CS-zein contained 96.5% protein, while LS-zein contained 74.5% protein, 12.7% lipid, 2.9% ash, and a residual fraction, likely starch remnants. SE-HPLC analysis showed that 27.8% of CS-zein protein occurred in an aggregated and insoluble form, while LS-zein mainly contained mono-/dimeric proteins but also approximately 30% hydrophilic peptides. These differences resulted in notably different behavior in the functionality of ZNPs based on CS- and LS-zein (CS-ZNPs and LS-ZNPs, respectively) produced via liquid antisolvent precipitation. CS-ZNPs had poor foaming properties regardless of the pH, in line with their low interfacial dilatational moduli (12.9-15.0 mN/m). The foaming properties of LS-ZNPs were notably better. The high LS-ZNP foam stability (FS) at pH 8.0 and 10.0 was attributed to electrostatic repulsive effects between interfaces of adjacent air bubbles due to the adsorption of peptides and to synergistic protein-lipid interaction effects at the air-water interface. The LS-ZNP FS at pH 4.0 was low despite a high interfacial dilatational modulus (52.6 mN/m). It is hypothesized that intact LS-ZNPs in the liquid thin films between gas bubbles negatively affect FS by a bridging de-wetting effect. Overall, it can be concluded that the (partial) co-isolation of lipids with zein may positively influence foaming properties of NPs based thereupon, while extensive zein purification as applied in industrial zein isolation leads to (partial) zein aggregation and overall low foaming capacity of the obtained CS-ZNPs.
Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.
(Copyright © 2024 Elsevier Ltd. All rights reserved.)
Databáze: MEDLINE
Externí odkaz: