Is step-cut shortening osteotomy a better choice than transverse osteotomy for total hip arthroplasty for Crowe type III-IV hip dysplasia?

Autor: Turgut N; Başkent University, Adana Dr. Turgut Noyan Research and Training Centre, Department of Orthopedics and Traumatology, Adana, Turkey. Electronic address: drnecmettinturgut@hotmail.com., Erdem M; Sakarya University Faculty of Medicine, Department of Orthopedics and Traumatology, Sakarya, Turkey., Erdem AC; Bezmialem Vakıf University Faculty of Medicine Department of Orthopedics and Traumatology, İstanbul, Turkey., Bayam L; İstanbul Medipol University, Department of Orthopedics and Traumatology, İstanbul, Turkey., Batar S; Ümraniye Training and Research Hospital, University of Health Sciences, Department of Orthopedics and Traumatology, İstanbul, Turkey., Sağlam N; Ümraniye Training and Research Hospital, University of Health Sciences, Department of Orthopedics and Traumatology, İstanbul, Turkey., Gülabi D; Marmara University Faculty of Medicine, Department of Orthopedics and Traumatology, İstanbul, Turkey.
Jazyk: angličtina
Zdroj: Orthopaedics & traumatology, surgery & research : OTSR [Orthop Traumatol Surg Res] 2024 Oct; Vol. 110 (6), pp. 103883. Date of Electronic Publication: 2024 Apr 06.
DOI: 10.1016/j.otsr.2024.103883
Abstrakt: Introduction: Total hip arthroplasty for developmental hip dysplasia is a challenging surgery due to anatomic abnormalities. Crowe III and Crowe IV hip dysplasia generally necessitates a subtrochanteric shortening osteotomy. Transverse and step-cut osteotomy are the most common procedures for shortening of femur although there is still no consensus which one is a superior method. The objective of this study was to demonstrate whether transverse or step-cut osteotomy is superior in hips who undergo arthroplasty for high riding hip dysplasia.
Hypothesis: Our hypothesis was that higher rates of union would be achieved in patients with Crowe III-IV hip dysplasia when the step-cut osteotomy was performed compared to transverse osteotomies.
Material and Methods: A total of 99 hips from 90 patients (9 bilateral, 81 unilateral; 79 female, 11 male), each with a minimum follow-up duration of two years, were included in this study. The hips were classified as Crowe III (n=16) or IV (n=83). All hips were implanted cementless. Transverse or step-cut osteotomy was chosen for osteotomy type. The clinical and functional outcomes were assessed using the Harris Hip Score (HHS), limb length discrepancy (LLD), and limping. The complications and management of these were noted. The union rates were compared between osteotomy types.
Results: The mean age at surgery was 48.8 (range, 21-79 years). The follow-up period was 64.3 months in average (range, 24 to 192 months). The mean Harris Hip Score before surgery was 35.6 (range, 18-50), and increased to 88.1 (range, 61-98) points at the most recent follow-up. The preoperative leg length discrepancy (LLD) measured 5.3cm (with a range of 3 to 6.8), while the postoperative LLD reduced to 0.8cm (with a range of 0 to 1.6). There were a total of 38 complications in 35 patients out of 99 cases, resulting in a complication rate of 38.4%. The most frequent complication observed was intraoperative femoral fractures, occurring in 13 cases. Residual limping was seen in 73.7% of all. Step-cut osteotomy was performed in 64 hips (35 CDH stem [Zimmer Biomet, Warsaw, IN, USA], 29 Wagner Cone stem [Zimmer Biomet, Warsaw, IN, USA]) and, transverse in 35 hips (22 CDH, 13 Wagner Cone). Six hips had nonunion problem and all of them were operated with a step-cut osteotomy (z-score: -7.12 and p<0.00001, Mann-Whitney U Test).
Conclusion: Transverse osteotomy may be a better option while performing a shortening subtrochanteric level osteotomy for total hip arthroplasty for Crowe III-IV hips.
Level of Evidence: Level III; observational retrospective cohort study.
(Copyright © 2024 Elsevier Masson SAS. All rights reserved.)
Databáze: MEDLINE