The influence of surgical technique guidance and surgeon's experience on the femoral head assembly in total hip arthroplasty.

Autor: Darowski M; Department of Orthopaedics, Rostock University Medical Center, Doberaner Straße 142, D-18057, Rostock, Germany. martinmarkus.darowski@med.uni-rostock.de., Ruehrmund L; Department of Orthopaedics, Rostock University Medical Center, Doberaner Straße 142, D-18057, Rostock, Germany., Kluess D; Department of Orthopaedics, Rostock University Medical Center, Doberaner Straße 142, D-18057, Rostock, Germany., Klinder A; Department of Orthopaedics, Rostock University Medical Center, Doberaner Straße 142, D-18057, Rostock, Germany., Bader R; Department of Orthopaedics, Rostock University Medical Center, Doberaner Straße 142, D-18057, Rostock, Germany., Mittelmeier W; Department of Orthopaedics, Rostock University Medical Center, Doberaner Straße 142, D-18057, Rostock, Germany.
Jazyk: angličtina
Zdroj: Archives of orthopaedic and trauma surgery [Arch Orthop Trauma Surg] 2024 May; Vol. 144 (5), pp. 2391-2401. Date of Electronic Publication: 2024 Apr 02.
DOI: 10.1007/s00402-024-05282-w
Abstrakt: Introduction: The importance of the assembly procedure on the taper connection strength is evident. However, existent surgical technique guides frequently lack comprehensive and precise instructions in this regard. The aim of our experimental study was to evaluate the influence of the surgical technique guide on the femoral head assembly procedure in surgeons with differing levels of experience in total hip arthroplasty.
Materials and Methods: Twenty-eight participants, divided into four groups based on their lifetime experience in total hip arthroplasty, conducted a femoral head assembly procedure in a simulated intraoperative environment before and after reviewing the surgical technique guide. Demographic information and the number of hammer blows were documented. Hammer velocity and impaction angle were recorded using an optical motion capturing system, while the impaction force was measured using a dynamic force sensor within the impactor.
Results: We observed a high variation in the number of hammer blows, maximum force, and impaction angle. Overall, the number of hammer blows decreased significantly from 3 to 2.2 after reviewing the surgical technique guide. The only significant intragroup difference in the number of hammer blows was observed in the group with no prior experience in total hip arthroplasty. No correlation was found between individual factors (age, weight, height) or experience and the measured parameters (velocity, maximum force and angle).
Conclusions: The present study demonstrated a high variation in the parameters of the femoral head assembly procedure. Consideration of the surgical technique guide was found to be a limited factor among participants with varying levels of experience in total hip arthroplasty. These findings underline the importance of sufficient preoperative training, to standardize the assembly procedure, including impaction force, angle, and use of instruments.
(© 2024. The Author(s).)
Databáze: MEDLINE
Externí odkaz: