| Autor: |
Kramar A; Department of Materials Science and Engineering and Chemical Engineering, Universidad Carlos III de Madrid, Avda. Universidad 30, 28911 Leganés, Spain.; Institute of Chemistry and Materials Álvaro Alonso Barba, IQMAAB, Universidad Carlos III de Madrid, Avda. Universidad 30, 28911 Leganés, Spain., Luxbacher T; Anton Paar GmbH, 8054 Graz, Austria., Moshfeghi Far N; Department of Materials Science and Engineering and Chemical Engineering, Universidad Carlos III de Madrid, Avda. Universidad 30, 28911 Leganés, Spain., González-Benito J; Department of Materials Science and Engineering and Chemical Engineering, Universidad Carlos III de Madrid, Avda. Universidad 30, 28911 Leganés, Spain.; Institute of Chemistry and Materials Álvaro Alonso Barba, IQMAAB, Universidad Carlos III de Madrid, Avda. Universidad 30, 28911 Leganés, Spain. |
| Abstrakt: |
Cellulose acetate (CA), a very promising derivative of cellulose, has come into the focus of research due to its highly desired good film-forming ability for food packaging applications. Frequently, this derivative is used in combination with other compounds (polymers, nanoparticles) in order to obtain active materials. Here, we report the preparation of thin films made of cellulose acetate loaded with chitosan (CS) using the solution blow spinning (SBS) method. Films are prepared by SBS processing of the polymers mixture solution, considering the following variables: (i) the concentration of cellulose acetate and chitosan in the solution and (ii) the solvent system consisting of acetic or formic acid. The prepared materials are characterized in terms of physical properties, roughness (optical profilometer), porosity, wettability (contact angle measurements), chemical structure (Fourier transform infrared spectrometry), and electrokinetic properties (zeta potential). SBS enables the preparation of CA/CS films with high water vapor permeability, high porosity, and also higher water contact angle compared with pure CA films. The electrokinetic properties of composites are influenced by the inclusion of chitosan, which causes a shift of the isoelectric point (IEP) towards higher pH values, but the magnitude of the shift is not in correlation with chitosan concentration. Adsorption kinetic studies using bovine serum albumin (BSA) as a model protein reveal that chitosan modified cellulose acetate films manifest low affinity towards proteins that suggests prevention of biofilm formation on its surface. |
