| Autor: |
Labis JP; King Abdullah Institute for Nanotechnology, King Saud University, Riyadh 11451, Saudi Arabia., Albrithen HA; King Abdullah Institute for Nanotechnology, King Saud University, Riyadh 11451, Saudi Arabia.; Department of Physics and Astronomy, College of Science, King Saud University, Riyadh 11451, Saudi Arabia., Hezam M; King Abdullah Institute for Nanotechnology, King Saud University, Riyadh 11451, Saudi Arabia., Ali Shar M; King Abdullah Institute for Nanotechnology, King Saud University, Riyadh 11451, Saudi Arabia., Algarni A; Department of Physics and Astronomy, College of Science, King Saud University, Riyadh 11451, Saudi Arabia., Alhazaa AN; King Abdullah Institute for Nanotechnology, King Saud University, Riyadh 11451, Saudi Arabia.; Department of Physics and Astronomy, College of Science, King Saud University, Riyadh 11451, Saudi Arabia., El-Toni AM; King Abdullah Institute for Nanotechnology, King Saud University, Riyadh 11451, Saudi Arabia., Alduraibi MA; Department of Physics and Astronomy, College of Science, King Saud University, Riyadh 11451, Saudi Arabia. |
| Abstrakt: |
In this paper, a unique hybrid approach to design and synthesize 2D/3D Al 2 O 3 -ZnO nanostructures by simultaneous deposition is presented. Pulsed laser deposition (PLD) and RF magnetron sputtering (RFMS) methods are redeveloped into a single tandem system to create a mixed-species plasma to grow ZnO nanostructures for gas sensing applications. In this set-up, the parameters of PLD have been optimized and explored with RFMS parameters to design 2D/3D Al 2 O 3 -ZnO nanostructures, including nanoneedles/nanospikes, nanowalls, and nanorods, among others. The RF power of magnetron system with Al 2 O 3 target is explored from 10 to 50 W, while the ZnO-loaded PLD's laser fluence and background gases are optimized to simultaneously grow ZnO and Al 2 O 3 -ZnO nanostructures. The nanostructures are either grown via 2-step template approach, or by direct growth on Si (111) and MgO<0001> substrates. In this approach, a thin ZnO template/film was initially grown on the substrate by PLD at ~300 °C under ~10 milliTorr (1.3 Pa) O 2 background pressure, followed by growth of either ZnO or Al 2 O 3 -ZnO, using PLD and RFMS simultaneously under 0.1-0.5 Torr (13-67 Pa), and Ar or Ar/O 2 background in the substrate temperate range of 550-700 °C. Growth mechanisms are then proposed to explain the formation of Al 2 O 3 -ZnO nanostructures. The optimized parameters from PLD-RFMS are then used to grow nanostructures on Au-patterned Al 2 O 3 -based gas sensor to test its response to CO gas from 200 to 400 °C, and a good response is observed at ~350 °C. The grown ZnO and Al 2 O 3 -ZnO nanostructures are quite exceptional and remarkable and have potential applications in optoelectronics, such in bio/gas sensors. |
