| Autor: |
Kapshammer A; Institute of Polymer Product Engineering, Altenberger Straße 69, 4040 Linz, Austria., Miron MC; Competence Center CHASE GmbH, Altenberger Straße 69, 4040 Linz, Austria., Dangl L; Greiner Perfoam GmbH-Eine Gesellschaft der NEVEON Gruppe, Mainstraße 1, 4470 Enns, Austria., Major Z; Institute of Polymer Product Engineering, Altenberger Straße 69, 4040 Linz, Austria. |
| Jazyk: |
angličtina |
| Zdroj: |
Polymers [Polymers (Basel)] 2023 Feb 14; Vol. 15 (4). Date of Electronic Publication: 2023 Feb 14. |
| DOI: |
10.3390/polym15040935 |
| Abstrakt: |
Laminated composites with thermoset matrices are already well established in major engineering fields like automotive and aviation. The primary drawbacks of such thermoset-based composites are the high cycle times required during manufacturing and their limited potential for recycling. Providing an alternative to thermoset-based composites, thermoplastic matrix materials gained more and more momentum by addressing these previously mentioned drawbacks. The preferred manufacturing technique for these materials employs fiber-reinforced thermoplastic tapes consolidated and formed together with a compatible substrate. The most critical aspect for all these applications is the stress or load transfer between the thermoplastic tapes and the substrate. If the interface is too weak and fails prior to the substrate or tape, a high amount of theoretical mechanical performance is lost. The presented research investigates the influence of variations in manufacturing parameters, within the industrially relevant process window, on the interface strength of the final composite. The investigated composite material consists of PPGF UD tapes consolidated on a PPGF mat substrate. In particular, the influence of the consolidation parameters of pressure, temperature, and time are of special interest. The results of this work reveal a 400% increase in the measured mean strain energy release rate upon increasing the consolidation time from 60 s to 120 s at a consolidation temperature of 230 °C and a pressure of one bar. In contrast to this, an increase in the consolidation pressure, at constant temperature and time, leads to a minor improvement in the G C value of 20%. For testing and characterizing the corresponding interface properties, a mandrel peel testing setup was employed. |
| Databáze: |
MEDLINE |
| Externí odkaz: |
|
|
Nepřihlášeným uživatelům se plný text nezobrazuje |
K zobrazení výsledku je třeba se přihlásit.
|
