| Autor: |
Maryon OO; Micron School of Materials Science & Engineering, Boise State University., Efaw CM; Micron School of Materials Science & Engineering, Boise State University., DelRio FW; Material, Physical, and Chemical Sciences Center, Sandia National Laboratories., Graugnard E; Micron School of Materials Science & Engineering, Boise State University; Center for Advanced Energy Studies., Hurley MF; Micron School of Materials Science & Engineering, Boise State University; Center for Advanced Energy Studies., Davis PH; Micron School of Materials Science & Engineering, Boise State University; Center for Advanced Energy Studies; pauldavis2@boisestate.edu. |
| Abstrakt: |
Kelvin probe force microscopy (KPFM), sometimes referred to as surface potential microscopy, is the nanoscale version of the venerable scanning Kelvin probe, both of which measure the Volta potential difference (VPD) between an oscillating probe tip and a sample surface by applying a nulling voltage equal in magnitude but opposite in sign to the tip-sample potential difference. By scanning a conductive KPFM probe over a sample surface, nanoscale variations in surface topography and potential can be mapped, identifying likely anodic and cathodic regions, as well as quantifying the inherent material driving force for galvanic corrosion. Subsequent co-localization of KPFM Volta potential maps with advanced scanning electron microscopy (SEM) techniques, including back scattered electron (BSE) images, energy dispersive spectroscopy (EDS) elemental composition maps, and electron backscattered diffraction (EBSD) inverse pole figures can provide further insight into structure-property-performance relationships. Here, the results of several studies co-localizing KPFM with SEM on a wide variety of alloys of technological interest are presented, demonstrating the utility of combining these techniques at the nanoscale to elucidate corrosion initiation and propagation. Important points to consider and potential pitfalls to avoid in such investigations are also highlighted: in particular, probe calibration and the potential confounding effects on the measured VPDs of the testing environment and sample surface, including ambient humidity (i.e., adsorbed water), surface reactions/oxidation, and polishing debris or other contaminants. Additionally, an example is provided of co-localizing a third technique, scanning confocal Raman microscopy, to demonstrate the general applicability and utility of the co-localization method to provide further structural insight beyond that afforded by electron microscopy-based techniques. |
