| Autor: |
Ramlan N; Academy of Contemporary Islamic Studies, Universiti Teknologi Mara (UiTM), Shah Alam 40450, Malaysia., Zubairi SI; Department of Food Sciences, Faculty of Science & Technology, Universiti Kebangsaan Malaysia, Bangi 43600, Malaysia.; Tasik Chini Research Centre (PPTC), Faculty of Science & Technology, Universiti Kebangsaan Malaysia, Bangi 43600, Malaysia., Maskat MY; Department of Food Sciences, Faculty of Science & Technology, Universiti Kebangsaan Malaysia, Bangi 43600, Malaysia. |
| Jazyk: |
angličtina |
| Zdroj: |
Molecules (Basel, Switzerland) [Molecules] 2022 May 25; Vol. 27 (11). Date of Electronic Publication: 2022 May 25. |
| DOI: |
10.3390/molecules27113388 |
| Abstrakt: |
Particle deposition on the surface of a drying chamber is the main drawback in the spray drying process, reducing product recovery and affecting the quality of the product. In view of this, the potential application of chemical surface modification to produce a hydrophobic surface that reduces the powder adhesion (biofouling) on the wall of the drying chamber is investigated in this study. A hydrophobic polydimethylsiloxane (PDMS) solution was used in the vertical dipping method at room temperature to determine the optimum coating parameters on borosilicate glass and stainless steel substrates, which were used to mimic the wall surface of the drying chamber, to achieve highly hydrophobic surfaces. A single-factor experiment was used to define the range of the PDMS concentration and treatment duration using the Response Surface Methodology (RSM). The Central Composite Rotatable Design (CCRD) was used to study the effects of the concentration of the PDMS solution (X 1 , %) and the treatment duration (X 2 , h) on the contact angle of the substrates (°), which reflected the hydrophobicity of the surface. A three-dimensional response surface was constructed to examine the influence of the PDMS concentration and treatment duration on contact angle readings, which serve as an indicator of the surface's hydrophobic characteristics. Based on the optimisation study, the PDMS coating for the borosilicate glass achieved an optimum contact angle of 99.33° through the combination of a PDMS concentration of X 1 = 1% ( w / v ) and treatment time of X 2 = 4.94 h, while the PDMS coating for the stainless steel substrate achieved an optimum contact angle of 98.31° with a PDMS concentration of X 1 = 1% ( w / v ) and treatment time of X 2 = 1 h. Additionally, the infrared spectra identified several new peaks that appeared on the PDMS-treated surfaces, which represented the presence of Si-O-Si, Si-CH 3 , CH 2 , and CH 3 functional groups for the substrates coated with PDMS. Furthermore, the surface morphology analysis using the Field Emission Scanning Electron Microscopy (FESEM) showed the presence of significant roughness and a uniform nanostructure on the surface of the PDMS-treated substrates, which indicates the reduction in wettability and the potential effect of unwanted biofouling on the spray drying chamber. The application of PDMS and PTFE on the optimally coated substrates successfully reduced the amount of full cream milk particles that adhered to the surface. The low surface energy of the treated surface (19-27 mJ/m 2 ) and the slightly higher surface tension of the full cream milk (54-59 mJ/m 2 ) resulted in a high contact angle (102-103°) and reduced the adhesion work on the treated substrates (41-46 mJ/m 2 ) as compared to the native substrates. |
| Databáze: |
MEDLINE |
| Externí odkaz: |
|
|
Nepřihlášeným uživatelům se plný text nezobrazuje |
K zobrazení výsledku je třeba se přihlásit.
|
