| Autor: |
Ribeiro MM; Engineering of Natural Resources of the Amazon Program, Federal University of Pará-UFPA, Belem 66075-110, Brazil., Pinheiro MA; Engineering of Natural Resources of the Amazon Program, Federal University of Pará-UFPA, Belem 66075-110, Brazil., Rodrigues JDS; Materials Engineering Program, Federal Institute of Education, Science and Technology of Pará-IFPA, Belem 66093-020, Brazil., Ramos RPB; Materials Engineering Program, Federal Institute of Education, Science and Technology of Pará-IFPA, Belem 66093-020, Brazil., Corrêa AC; Materials Engineering Program, Federal Institute of Education, Science and Technology of Pará-IFPA, Belem 66093-020, Brazil., Monteiro SN; Materials Science Program, Military Institute of Engineering-IME, Rio de Janeiro 22290-270, Brazil., da Silva ACR; Materials Science and Engineering Program, Federal University of Pará-UFPA, Ananindeua 67130-660, Brazil., Candido VS; Engineering of Natural Resources of the Amazon Program, Federal University of Pará-UFPA, Belem 66075-110, Brazil. |
| Abstrakt: |
Mechanical properties of composites reinforced with lignocellulosic fibers have been researched in recent decades. Jute and mallow fibers are reinforcement alternatives, as they can contribute to increase the mechanical strength of composite materials. The present work aims to predict the Young's modulus with application of continuous and aligned lignocellulosic fibers to be applied as reinforcement in polyester matrix. Fibers were manually separated and then arranged and aligned in the polyester matrix. Composites with addition 5, 15, and 25 vol% jute and mallow fibers were produced by vacuum-assisted hand lay-up/vaccum-bagging procedure. Samples were tested in tensile and the tensile strength, elasticity modulus, and deformation were determined. Results showed that the intrinsic Young's modulus of the fibers was set at values around 17.95 and 11.72 GPa for jute and mallow fibers, respectively. Statistical analysis showed that composites reinforced with 15 and 25 vol% jute and mallow presented the highest values of tensile strength and Young's modulus. The incorporation of 25 vol% of jute and mallow fibers increased the matrix Young's modulus by 534% and 353%, respectively, effectively stiffening the composite material. Prediction models presented similar values for the Young's modulus, showing that jute and mallow fibers might be used as potential reinforcement of polymeric matrices. |
