| Autor: |
Hossain Bhuiyan ME; Department of Mechanical Engineering, The University of Texas at Dallas, Richardson, Texas 75080, United States., Moreno S; Department of Mechanical Engineering, The University of Texas at Dallas, Richardson, Texas 75080, United States., Wang C; Department of Mechanical Engineering, The University of Texas at Dallas, Richardson, Texas 75080, United States., Minary-Jolandan M; Department of Mechanical Engineering, The University of Texas at Dallas, Richardson, Texas 75080, United States. |
| Jazyk: |
angličtina |
| Zdroj: |
ACS applied materials & interfaces [ACS Appl Mater Interfaces] 2021 Apr 28; Vol. 13 (16), pp. 19271-19281. Date of Electronic Publication: 2021 Apr 15. |
| DOI: |
10.1021/acsami.1c01890 |
| Abstrakt: |
The metallic interconnects are essential components of energy devices such as fuel cells and electrolysis cells, batteries, as well as electronics and optoelectronic devices. In recent years, 3D printing processes have offered complementary routes to the conventional photolithography- and vacuum-based processes for interconnect fabrication. Among these methods, the confined electrodeposition (CED) process has enabled a great control over the microstructure of the printed metal, direct printing of high electrical conductivity (close to the bulk values) metals on flexible substrates without a need to sintering, printing alloys with controlled composition, printing functional metals for various applications including magnetic applications, and for in situ scanning electron microscope (SEM) nanomechanical experiments. However, the metal deposition rate (or the overall printing speed) of this process is reasonably slow because of the chemical nature of the process. Here, we propose using the CED process to print a single layer of a metallic trace as the seed layer for the subsequent selected-area electroless plating. By controlling the activation sites through printing by the CED process, we control, where the metal grows by electroless plating, and demonstrate the fabrication of complex thin-film patterns. Our results show that this combined process improves the processing time by more than 2 orders of magnitude compared to the layer-by-layer printing process by CED. Additionally, we obtained Cu and Ni films with an electrical resistivity as low as ∼1.3 and ∼2 times of the bulk Cu and Ni, respectively, without any thermal annealing. Furthermore, our quantitative experiments show that the obtained films exhibit mechanical properties close to the bulk metals with an excellent adhesion to the substrate. We demonstrate potential applications for radio frequency identification (RFID) tags, for complex printed circuit board patterns, and resistive sensors in a Petri dish for potential biological applications. |
| Databáze: |
MEDLINE |
| Externí odkaz: |
|
