Influence of surface sealant and erosive challenge on the color change of composite resin subjected to artificial staining.
| Autor: | Moreira JC, Prata J X Nior AR, do Nascimento YA, Francisconi-Dos-Rios LF, da Rocha DM, Nahsan FPS |
|---|---|
| Jazyk: | angličtina |
| Zdroj: | General dentistry [Gen Dent] 2020 Nov-Dec; Vol. 68 (6), pp. 29-33. |
| Abstrakt: | The aim of this study was to evaluate the influence of surface sealant and erosive challenge on the color change of composite resin after artificial staining with coffee. Forty-eight composite specimens (8 × 1 mm) were prepared and divided into 4 groups (n = 12) based on the timing of sealant application (immediate vs delayed) and exposure to acid (erosive challenge vs no challenge). The groups were subjected to the procedures in the following order: 1, sealant application, erosive challenge, color measurement, coffee immersion, and color measurement; 2, sealant application, color measurement, coffee immersion, and color measurement; 3, erosive challenge, color measurement, sealant application, coffee immersion, and color measurement; and 4, color measurement, sealant application, coffee immersion, and color measurement. In groups 1 and 2, surface sealant was applied immediately after preparation of the specimens. In groups 3 and 4, sealant was applied after the first color measurement. Color was measured with a spectrophotometer using the CIE L*a*b* system. The erosive challenge (groups 1 and 3) was carried out in 0.01M hydrochloric acid, 150 mL/cycle, at room temperature (2-minute immersions 4 times a day for 5 days). After all specimens were immersed in coffee for 14 days, new color measurements were performed. For total color change (∆E*), groups 1 (21.01) and 2 (23.10) presented lower values than groups 3 (27.76) and 4 (26.57). For luminosity (∆L*), the opposite occurred (groups: 1, -16.84; 2, -17.72; 3, -22.62; and 4, -21.22). For ∆a* and ∆b*, the only statistically significant difference was the group 1 ∆b* value, which was the lowest among all groups. The opacity remained stable in all groups. The results suggest that resin luminosity decreases and color variation increases when surface sealant is applied after erosive cycling and storage. Competing Interests: The authors report no conflicts of interest pertaining to any of the products or companies discussed in this article. |
| Databáze: | MEDLINE |
| Externí odkaz: |
|