| Autor: |
Kiani SH; Electrical Engineering Department, City University of Science and Information Technology, Peshawar 25000, Pakistan., Altaf A; Electrical Engineering Department, Istanbul Medipol University, Istanbul 34083, Turkey., Abdullah M; Department of Computer Science, Bacha Khan University, Charsadda 24420, Pakistan., Muhammad F; Electrical Engineering Department, University of Engineering and Technology, Mardan 23200, Pakistan., Shoaib N; Research Institute for Microwave and Millimeter-Wave Studies, National University of Sciences and Technology, Islamabad 44000, Pakistan., Anjum MR; Department of Electronic Engineering, The Islamia University of Bahawalpur, Bahawalpur 63100, Pakistan., Damaševičius R; Department of Software Engineering, Kaunas University of Technology, LT-51423 Kaunas, Lithuania., Blažauskas T; Department of Software Engineering, Kaunas University of Technology, LT-51423 Kaunas, Lithuania. |
| Abstrakt: |
This paper presents a novel design of a Multiple Input Multiple Output (MIMO) antenna system for next generation sub 6 GHz 5G and beyond mobile terminals. The proposed system is composed of a main board and two side boards. To make the design cost-effective, FR4 is used as a substrate. The design is based on a unit monopole antenna etched at the side substrate. The single element is resonating at 3.5 GHz attaining a 10 dB bandwidth of 200 MHz and a 6 dB bandwidth of 400 MHz. The single element is then transformed into an MIMO array of 8-elements with an overall dimension of 150 mm × 75 mm × 7 mm, providing pattern diversity characteristics and isolation better than -12 dB for any two radiating elements. A number of studies such as effects of human hand on the system that includes single hand mode and dual mode scenarios and the effects of Liquid Crystal Display (LCD) over the principal performance parameters of the system are presented. The envelop correlation coefficient (ECC) is computed for all the scenarios and it is found that ECC is less than 0.1 for any case and maximum channel capacity is 38.5 bps/Hz within the band of interest. The main advantage of the proposed design over available designs in the literature is that almost all of the main substrate is empty providing wide space for different sensors, systems, and mobile technology components. A brief literature comparison of the proposed system is also presented. To validate the proposed model, a prototype is fabricated and results are presented. This design can be applied on higher frequencies to future micromachines for on chip communications using same theocratical approach as the space for higher frequencies in mmwave spectrum has been reserved. The simulated results are in an excellent agreement with the measured results. All the main performance parameters of the design are calculated and compared with the measured results wherever possible. |
