| Autor: |
Munuswamy DB; Department of Mechanical Engineering, Panimalar Engineering College, Poonamallee, Chennai, 600123, India. dinesh198014@yahoo.com., Devarajan Y; Department of Mechanical Engineering, Madanapalle Institute of Technology and Science, Madanapalle, Andhra Pradesh, India., Babu MN; Department of Mechanical Engineering, GRT Institute of Engineering and Technology, Tiruttani, Tamil Nadu, India., Ramalingam S; Department of Mechanical Engineering, Panimalar Engineering College, Poonamallee, Chennai, 600123, India. |
| Jazyk: |
angličtina |
| Zdroj: |
Environmental science and pollution research international [Environ Sci Pollut Res Int] 2020 Dec; Vol. 27 (36), pp. 45390-45404. Date of Electronic Publication: 2020 Aug 13. |
| DOI: |
10.1007/s11356-020-10311-3 |
| Abstrakt: |
The main objective of this study is to lower the greenhouse gases by developing and optimizing a solar flat plate collector. The rifled tube is integrated into the collector to increase the thermal heat transfer thereby improving its performance. Two flat plate collectors, one with in-housed longitudinal fins and another without fins of 0.5 m 2 collector area, have been intended and fabricated with provisions for K-type thermocouples to examine the temperature variations inside the collector for different working fluids. This current study reveals using CuO and Al 2 O 3 nanoparticles in varying weight fractions in incremental order to study the effect of weight fractions on the efficiency of the collector. The simulation was done using computational fluid dynamics both for the finned and without finned tube collectors separately and the outcome of the results for the collector outlet temperatures is compared with the experimental one and results show a valuable outcome for the intended collectors. Initially, the test was conducted with pure distilled water as working fluid and further nanoparticles were opted and doped inside the collector side for varying weight fractions of 0.2% and 0.4% and their results are compared. The experimental results showed an improved heat transfer was pragmatic in the collector side for using nanoparticles. Mixing the nanofluids exhibited superior efficiency on the collector side. The results showed after successful trials of experimentation, doping of CuO nanoparticles by varying weight fractions of 0.2% and 0.4%, augmentation of the collector (unfinned) efficiency is 2.1% and 4.05%, and similarly for finned tube collector, it is 3.02% and 5.5% for same weight fractions. In order to improve the thermal efficiency of collector, CuO is replaced by Al 2 O 3 nanoparticles; for dissimilar weight fractions, the efficiency is enhanced nearly by 3.7% and 6.54% for unfinned tube collector, and for the finned tube, the collector is 4.8% and 7.8% respectively, compared with the base working fluid (water). Experimentation of the collectors with finned tube type achieved a superior efficiency compared with that of unfinned tube collectors which is proved to be higher when used for nanofluids to that of the base working fluid water. |
| Databáze: |
MEDLINE |
| Externí odkaz: |
|
Full text from SpringerLink