| Autor: |
Ahmad H; School of Electrical and Computer Engineering, Georgia Institute of Technology, 777 Atlantic Dr NW, Atlanta, Georgia 30332-0250, United States., Motoki K; School of Electrical and Computer Engineering, Georgia Institute of Technology, 777 Atlantic Dr NW, Atlanta, Georgia 30332-0250, United States., Clinton EA; School of Electrical and Computer Engineering, Georgia Institute of Technology, 777 Atlantic Dr NW, Atlanta, Georgia 30332-0250, United States., Matthews CM; School of Electrical and Computer Engineering, Georgia Institute of Technology, 777 Atlantic Dr NW, Atlanta, Georgia 30332-0250, United States., Engel Z; School of Electrical and Computer Engineering, Georgia Institute of Technology, 777 Atlantic Dr NW, Atlanta, Georgia 30332-0250, United States., Doolittle WA; School of Electrical and Computer Engineering, Georgia Institute of Technology, 777 Atlantic Dr NW, Atlanta, Georgia 30332-0250, United States. |
| Abstrakt: |
While metal modulated epitaxy (MME) has been shown useful for hyperdoping, where hole concentrations 40 times higher than other techniques have been demonstrated, and the ability to control phase separation in immiscible III-nitrides, the complexity of the dynamically changing surface conditions during the cyclic growth is poorly understood. While MME is capable of superb crystal quality, performing MME in an improper growth regime can result in defective material. These complications have made the transfer of MME knowledge challenging. This work provides a comprehensive study of the conditions necessary for achieving the benefits of MME while avoiding undesirable defects. The effects of growth temperature, Ga/N ratio, and excess Ga dose per MME growth cycle on the morphological, structural, electronic, and optical properties of unintentionally doped (UID) MME grown gallium nitride (GaN) have been investigated. Optimal structural and electrical quality were achieved for GaN films grown at ∼650 °C, at pre-bilayer Ga coverage and at the moderate droplet regime. However, high defect concentrations were observed at the lowest growth temperatures, and counter to traditional MBE, as the excess Ga dose transitioned from bilayer coverage to the low droplet regime. Optoelectronic properties were optimal for films grown at intermediate growth temperatures, an excess Ga dose condition just before the droplet formation, and, at a III/V ratio of 1.3. Optimization of growth temperatures, Ga/N ratios, and excess Ga dose results in a range of growth conditions achieving smooth surfaces, step-flow surface morphology, and high crystalline quality films with low threading dislocation densities, allowing researchers to utilize the extensive advantages of MME. |
