Nonisocyanate Poly(Hydroxyl Urethane)-Based Green Polymer Hybrid Coating Systems: Tailoring of Biomacromolecular Compound Architecture Using APTMS-ZnO/TEMPO-Oxidized Cellulose Nanoparticles.

Autor: Haniffa MACM; Advanced Materials Center, Faculty of Engineering, University of Malaya, Malaysia, 50603 Kuala Lumpur, Malaysia.; Department of Electrical Engineering, Faculty of Engineering, University of Malaya, Malaysia, 50603 Kuala Lumpur, Malaysia.; Department of Chemistry, Faculty of Science, University of Malaya, Malaysia, 50603 Kuala Lumpur, Malaysia., Illias HA; Advanced Materials Center, Faculty of Engineering, University of Malaya, Malaysia, 50603 Kuala Lumpur, Malaysia.; Department of Electrical Engineering, Faculty of Engineering, University of Malaya, Malaysia, 50603 Kuala Lumpur, Malaysia., Chee CY; Advanced Materials Center, Faculty of Engineering, University of Malaya, Malaysia, 50603 Kuala Lumpur, Malaysia.; Department of Chemical Engineering, Faculty of Engineering, University of Malaya, Malaysia, 50603 Kuala Lumpur, Malaysia., Ibrahim S; Institute of Ocean and Earth Sciences, Deputy Vice Chancellor (Research & Innovation) Office, University of Malaya, Malaysia, 50603 Kuala Lumpur, Malaysia., Sandu V; Dept. Magnetism and Superconductivity, National Institute of Materials Physics, 105 bis Atomistilor Str., Magurele, J.Ilfov, POBox MG-7, 077125 Romania., Chuah CH; Department of Chemistry, Faculty of Science, University of Malaya, Malaysia, 50603 Kuala Lumpur, Malaysia.
Jazyk: angličtina
Zdroj: ACS omega [ACS Omega] 2020 May 01; Vol. 5 (18), pp. 10315-10326. Date of Electronic Publication: 2020 May 01 (Print Publication: 2020).
DOI: 10.1021/acsomega.9b04388
Abstrakt: Hybrid bionanocomposite coating systems (HBCSs) are green polymer materials consisting of an interface between a coating matrix and nanoparticles. The coating matrix was prepared by using a nonisocyanate poly(hydroxyl urethane) (NIPHU) prepolymer crosslinked via 1,3-diaminopropane and epoxidized Jatropha curcas oil. TEMPO-oxidized cellulose nanoparticles (TARC) were prepared from microcrystalline cellulose, and (3-aminopropyl)trimethoxysilane (APTMS)-coated ZnO nanoparticles (APTMS-ZnO) and their suspensions were synthesized separately. The suspensions at different weight ratios were incorporated into the coating matrix to prepare a series of HBCSs. FT-IR, 1 H-NMR, 13 C-NMR, XRD, SEM, and TEM were used to confirm the chemical structures, morphology, and elements of the coating matrix, nanomaterials, and HBCSs. The thermomechanical properties of the HBCSs were investigated by TGA-DTG and pencil hardness analyses. The UV and IR absorption spectra of the HBCSs were obtained using UV-vis spectroscopy and FTIR spectroscopy, respectively. The HBCSs exhibited good thermal stability at about 200 °C. The degradation temperature at 5% mass loss of all samples was over around 280 °C. The HBCSs exhibited excellent UV block and IR active properties with a stoichiometric ratio of the NIPHU prepolymer and EJCO of 1:1 (wt/wt) containing 5 wt % TARC and 15 wt % APTMS-ZnO nanoparticles. It was observed that the sample with 5 wt % TARC and 15 wt % APTMS-ZnO (HBCS-2) exhibited a uniform crosslinking and reinforcement network with a T onset of 282 °C. This sample has successfully achieved good coating hardness and excellent UV and IR absorption.
Competing Interests: The authors declare no competing financial interest.
(Copyright © 2020 American Chemical Society.)
Databáze: MEDLINE
Externí odkaz: