Off-axis loads cause failure of the distal radius at lower magnitudes than axial loads: A side-to-side experimental study.

Autor: Johnston JD; Department of Mechanical Engineering, College of Engineering, University of Saskatchewan, Saskatoon, Saskatchewan, Canada., McDonald MP; Department of Mechanical Engineering, College of Engineering, University of Saskatchewan, Saskatoon, Saskatchewan, Canada., Kontulainen SA; College of Kinesiology, University of Saskatchewan, Saskatoon, Saskatchewan, Canada.
Jazyk: angličtina
Zdroj: Journal of orthopaedic research : official publication of the Orthopaedic Research Society [J Orthop Res] 2020 Aug; Vol. 38 (8), pp. 1688-1692. Date of Electronic Publication: 2020 Jan 31.
DOI: 10.1002/jor.24601
Abstrakt: Off-axis loading associated with a fall onto the outstretched hand has been hypothesized to induce distal radius failure at lower magnitudes than axially directed loading commonly used in biomechanical models for estimating fracture risk. However, this hypothesis has not been tested with side-to-side experimental testing. The objective of this study was to compare distal radius failure loads between forearm pairs experimentally tested in an axial or off-axis loading configuration. We acquired 18 pairs of cadaveric forearms from 18 female donors (mean age (standard deviation): 84.4 (7.9) years). Each forearm pair was tested to failure using either an axial compression test (vertical orientation with 0° dorsal inclination, 3°-6° radial inclination) or an off-axis test corresponding to the hand position during a fall (15° dorsal inclination, 3°-6° radial inclination). Failure testing was performed at 3 mm/s onto the palm of the hand until fracture occurred. Of the 18 pairs, 11 sustained a distal radius fracture. We compared failure loads between the two groups using a paired t test. Results indicated that failure load under off-axis loading was 29% lower than failure load under axial compressive loading (mean difference: -0.31 kN; 95% confidence interval: -0.47 to -0.16 kN, P = .001). In conclusion, off-axis loading associated with a fall onto the outstretched hand resulted in a 29% lower failure load. Integrating an off-axis loading configuration into current biomechanical models of distal radius bone strength may prevent overestimating of failure load and may offer a clinically relevant option to estimate distal radius fracture risk and monitor therapy efficacy.
(© 2020 Orthopaedic Research Society. Published by Wiley Periodicals, Inc.)
Databáze: MEDLINE
Externí odkaz: