Thermal desorption and pyrolysis direct analysis in real time mass spectrometry for qualitative characterization of polymers and polymer additives.

Autor: Cody RB; JEOL USA, Inc., Peabody, Massachusetts., Fouquet TNJ; Research Institute for Sustainable Chemistry, National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba, Japan., Takei C; Biochromato Inc., 1-12-19 Honcho, Fujisawa, Kanagawa-ken, Japan.
Jazyk: angličtina
Zdroj: Rapid communications in mass spectrometry : RCM [Rapid Commun Mass Spectrom] 2020 Aug; Vol. 34 Suppl 2, pp. e8687. Date of Electronic Publication: 2020 Feb 19.
DOI: 10.1002/rcm.8687
Abstrakt: Rationale: Direct analysis in real time mass spectrometry (DART-MS) provides qualitative information about additives and polymer composition. However, the observed mass spectra are dependent on sampling conditions, in particular the DART gas temperature. This report describes the combination of a heated sample stage with DART-MS for polymer characterization.
Methods: Industrial polymers with different compositions were examined by thermal desorption and pyrolysis (TDPy) DART. Samples were heated on disposable copper stages from ambient temperature to 600°C, and the evolved gases were introduced directly into a DART ion source through a glass tee. Time- and temperature-dependent mass spectra were acquired using a high-resolution time-of-flight mass spectrometer. Kendrick mass analysis was applied to the interpretation of complex mass spectra observed for fluorinated polymers.
Results: Positive-ion DART mass spectra of common polymers exhibited peak series differing by monomer masses, often accompanied by a peak corresponding to the protonated monomer. Even polymers that did not exhibit a clear series of peaks produced characteristic mass spectra. Positive-ion and negative-ion mass spectra were recorded for fluorinated polymers, with polytetrafluoroethylene (PTFE) producing only negative ions. Thermal desorption provided characteristic temperature profiles for volatile species such as polymer additives and polymer pyrolysis products.
Conclusions: In comparison with direct analysis by positioning sample directly in the heated DART gas stream, TDPy DART provides a more versatile sampling method and provides thermal separation and profiling of polymer additives, intact short polymer chains, and pyrolysis fragments.
(© 2019 John Wiley & Sons, Ltd.)
Databáze: MEDLINE
Externí odkaz: