| Autor: |
Qu G; Department of Chemical and Biomolecular Engineering, University of Illinois Urbana-Champaign , 600 S. Mathews Avenue, Urbana, Illinois 61801, United States., Zhao X; Department of Chemistry, Purdue University , West Lafayette, Indiana 47907, United States., Newbloom GM; Department of Chemical Engineering, University of Washington , Box 351750, Seattle, Washington 98195-1750, United States., Zhang F; Department of Chemical and Biomolecular Engineering, University of Illinois Urbana-Champaign , 600 S. Mathews Avenue, Urbana, Illinois 61801, United States., Mohammadi E; Department of Chemical and Biomolecular Engineering, University of Illinois Urbana-Champaign , 600 S. Mathews Avenue, Urbana, Illinois 61801, United States., Strzalka JW; X-ray Science Division, Argonne National Laboratory , Argonne, Illinois 60439, United States., Pozzo LD; Department of Chemical Engineering, University of Washington , Box 351750, Seattle, Washington 98195-1750, United States., Mei J; Department of Chemistry, Purdue University , West Lafayette, Indiana 47907, United States., Diao Y; Department of Chemical and Biomolecular Engineering, University of Illinois Urbana-Champaign , 600 S. Mathews Avenue, Urbana, Illinois 61801, United States. |
| Abstrakt: |
Domain alignment in conjugated polymer thin films can significantly enhance charge carrier mobility. However, the alignment mechanism during meniscus-guided solution coating remains unclear. Furthermore, interfacial alignment has been rarely studied despite its direct relevance and critical importance to charge transport. In this study, we uncover a significantly higher degree of alignment at the top interface of solution coated thin films, using a donor-acceptor conjugated polymer, poly(diketopyrrolopyrrole-co-thiophene-co-thieno[3,2-b]thiophene-co-thiophene) (DPP2T-TT), as the model system. At the molecular level, we observe in-plane π-π stacking anisotropy of up to 4.8 near the top interface with the polymer backbone aligned parallel to the coating direction. The bulk of the film is only weakly aligned with the backbone oriented transverse to coating. At the mesoscale, we observe a well-defined fibril-like morphology at the top interface with the fibril long axis pointing toward the coating direction. Significantly smaller fibrils with poor orientational order are found on the bottom interface, weakly aligned orthogonal to the fibrils on the top interface. The high degree of alignment at the top interface leads to a charge transport anisotropy of up to 5.4 compared to an anisotropy close to 1 on the bottom interface. We attribute the formation of distinct interfacial morphology to the skin-layer formation associated with high Peclet number, which promotes crystallization on the top interface while suppressing it in the bulk. We further infer that the interfacial fibril alignment is driven by the extensional flow on the top interface arisen from increasing solvent evaporation rate closer to the meniscus front. |
