| Autor: |
Dolleman RJ; Kavli Institute of Nanoscience, Delft University of Technology , Lorentzweg 1, 2628CJ, Delft, The Netherlands., Davidovikj D; Kavli Institute of Nanoscience, Delft University of Technology , Lorentzweg 1, 2628CJ, Delft, The Netherlands., Cartamil-Bueno SJ; Kavli Institute of Nanoscience, Delft University of Technology , Lorentzweg 1, 2628CJ, Delft, The Netherlands., van der Zant HS; Kavli Institute of Nanoscience, Delft University of Technology , Lorentzweg 1, 2628CJ, Delft, The Netherlands., Steeneken PG; Kavli Institute of Nanoscience, Delft University of Technology , Lorentzweg 1, 2628CJ, Delft, The Netherlands. |
| Abstrakt: |
The operating principle of squeeze-film pressure sensors is based on the pressure dependence of a membrane's resonance frequency, caused by the compression of the surrounding gas which changes the resonator stiffness. To realize such sensors, not only strong and flexible membranes are required, but also minimization of the membrane's mass is essential to maximize responsivity. Here, we demonstrate the use of a few-layer graphene membrane as a squeeze-film pressure sensor. A clear pressure dependence of the membrane's resonant frequency is observed, with a frequency shift of 4 MHz between 8 and 1000 mbar. The sensor shows a reproducible response and no hysteresis. The measured responsivity of the device is 9000 Hz/mbar, which is a factor 45 higher than state-of-the-art MEMS-based squeeze-film pressure sensors while using a 25 times smaller membrane area. |
