Effect of initial moisture content and chip size on the bioconversion efficiency of softwood lignocellulosics.

Autor: Cullis IF; Department of Wood Science, University of British Columbia, 2424 Main Mall, Vancouver, B.C., V6T 1Z4, Canada., Saddler JN, Mansfield SD
Jazyk: angličtina
Zdroj: Biotechnology and bioengineering [Biotechnol Bioeng] 2004 Feb 20; Vol. 85 (4), pp. 413-21.
DOI: 10.1002/bit.10905
Abstrakt: Previous optimization strategies for the bioconversion of lignocellulosics by steam explosion technologies have focused on the effects of temperature, pH, and treatment time, but have not accounted for changes in severity brought about by properties inherent in the starting feedstock. Consequently, this study evaluated the effects of chip properties, feedstock size (40-mesh, 1.5 x 1.5 cm, 5 x 5 cm), and moisture content (12% and 30%) on the overall bioconversion process, and more specifically on the efficacy of removal of recalcitrant lignin from the lignocellulosic substrates following steam explosion. Increasing chip size resulted in an improvement in the solids recovery, with concurrent increases in the water soluble, hemicellulose-derived sugar recovery (7.5%). This increased recovery is a result of a decrease in the "relative severity" of the pretreatment as chip size increases. Additionally, the decreased relative severity minimized the condensation of the recalcitrant residual lignin and therefore increased the efficacy of peroxide fractionation, where a 60% improvement in lignin removal was possible with chips of larger initial size. Similarly, increased initial moisture content reduced the relative severity of the pretreatment, generating improved solids and hemicellulose-derived carbohydrate recovery. Both increased chip size and higher initial moisture content results in a substrate that performs better during peroxide delignification, and consequently enzymatic hydrolysis. Furthermore, a post steam-explosion refining step increased hemicellulose-derived sugar recovery and was most effectively delignified (to as low as 6.5%). The refined substrate could be enzymatically hydrolyzed to very high levels (98%) and relatively fast rates (1.23 g/L/h).
(Copyright 2004 Wiley Periodicals, Inc.)
Databáze: MEDLINE
Externí odkaz: