| Autor: |
Fitz DR; College of Engineering-Center for Environmental Research and Technology, University of California, Riverside 92521-0434, USA., Motallebi N |
| Jazyk: |
angličtina |
| Zdroj: |
Journal of the Air & Waste Management Association (1995) [J Air Waste Manag Assoc] 2000 Jun; Vol. 50 (6), pp. 981-92. |
| DOI: |
10.1080/10473289.2000.10464134 |
| Abstrakt: |
A new style of diffusion denuder has been evaluated specifically for sampling HNO3. A coated fabric is used as the denuder substrate, which can be loaded directly into a standard filter holder. This approach allows direct denuder sampling with no additional capital costs over filter sampling and simplifies the coating and extraction process. Potential denuder materials and coatings were evaluated in the laboratory to test the removal efficiency. NaCl coatings were used to assess more than 20 materials for HNO3 collection efficiency. Particle retention, which would cause a denuder to have a positive bias for gas concentration measurements, was evaluated by ambient air sampling using particulate sulfate as the reference aerosol. Particle retention varied from 0 to 15%, depending on the denuder material tested. The best performing material showed an average particle retention of less than 3%. Denuder efficiency of four fabric materials was tested under ambient conditions to determine removal efficiency. The fabric denuder method was compared with a long path-length Fourier transform infrared (FTIR) spectrometer, a tunable diode laser absorption spectrometer (TDLAS), and a denuder difference sampler to independently measure HNO3. HNO3 collection efficiency was typically 90% for the denuders, whether coated with NaCl or not. For 10-L/min sampling rates with the fabric denuder, the square of the correlation coefficient with the FTIR spectrometer was 0.73, compared to 0.24 with the TDLAS. |
| Databáze: |
MEDLINE |
| Externí odkaz: |
|
