| Autor: |
Ye Jin Kim, Young Min Kim, Jun Ho Bae, Soo-Hyun Joo, Sung Hyuk Park |
| Jazyk: |
angličtina |
| Rok vydání: |
2023 |
| Předmět: |
|
| Zdroj: |
Journal of Magnesium and Alloys, Vol 11, Iss 3, Pp 892-902 (2023) |
| Druh dokumentu: |
article |
| ISSN: |
2213-9567 |
| DOI: |
10.1016/j.jma.2021.12.015 |
| Popis: |
The commercial AZ91 alloy and nonflammable SEN9 (AZ91–0.3Ca–0.2Y, wt%) alloy are extruded at 300 °C and 400 °C. Their microstructure, tensile and compressive properties, and low-cycle fatigue (LCF) properties are investigated, with particular focus on the influence of the extrusion temperature. In the AZ91 and SEN9 materials extruded at 300 °C (300-materials), numerous fine Mg17Al12 particles are inhomogeneously distributed owing to localized dynamic precipitation during extrusion, unlike those extruded at 400 °C (400-materials). These fine particles suppress the coarsening of recrystallized grains, decreasing the average grain size of 300-materials. Although the four extruded materials have considerably different microstructures, the difference in their tensile yield strengths is insignificant because strong grain-boundary hardening and precipitation hardening effects in 300-materials are offset almost completely by a strong texture hardening effect in 400-materials. However, owing to their finer grains and weaker texture, 300-materials have higher compressive yield strengths than 400-materials. During the LCF tests, {10–12} twinning is activated at lower stresses in 400-materials than in 300-materials. Because the fatigue damage accumulated per cycle is smaller in 400-materials, they have longer fatigue lives than those of 300-materials. A fatigue life prediction model for the investigated materials is established on the basis of the relationship between the total strain energy density (∆Wt) and the number of cycles to fatigue failure (Nf), and it is expressed through a simple equation (∆Wt = 10·Nf−0.59). This model enables fatigue life prediction of both the investigated alloys regardless of the extrusion temperature and strain amplitude. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
