| Popis: |
Functionally graded materials (FGM) do not show special processing in the composite structure due to the combination of mechanical, thermal, magnetic and stress gradient properties. The aim of this study is to produce IN718/St6 FGM samples by direct laser deposition method. The product of this model should enable the development of mechanical products. Best of all, this can be done without significant reduction in texture and case to residual stress that are a consequence of rapid changes in mechanical and thermal properties in non-FGM samples. To fabricate part, direct laser deposition system equipped with a 1 kW continuous fiber laser is used, SEM/EDS analysis and microhardness testing to measure porosity, chemical composition, and quantify gradient mechanical properties is used. In this study, the cladding composition is selected from 100% IN718 to 100% St6 with a 25% change in St6 composition. To prevent the formation of defects, both single-parameter modes and individual layering are examined, considering the diverse nature of the combination. The result shows that using an individual layering structure, reduces 100% Lack of fusion defects in the IN718/St6 structure. EDS analysis confirmed that the St6 content gradually increased from the first to the fifth layer. The substrate hardness gradually increases from 200 Vickers hardness to 550 Vickers hardness, showing an almost linear trend. Moreover, by using individual layering, the coaxial structure is reduced by 55% and the relative orientation of the vertical line is reduced by 18° compared to using the St6 directly (non-FGM). |
