| Autor: |
Janostik Vaclav, Stanek Michal, Manas David, Manas Miroslav, Senkerik Vojtech |
| Jazyk: |
English<br />French |
| Rok vydání: |
2016 |
| Předmět: |
|
| Zdroj: |
MATEC Web of Conferences, Vol 76, p 02022 (2016) |
| Druh dokumentu: |
article |
| ISSN: |
2261-236X |
| DOI: |
10.1051/matecconf/20167602022 |
| Popis: |
This experimental study describes the influence of runner system on rheological properties during the injection molding process. Economic effects on the amount of production are discussed as well. Autodesk Moldflow Synergy 2016 (Moldflow) was used for the study of the injection process. Three suggestions of the runner system, cold runner system, hot runner system and the combination of cold–hot runner system have been promoted. These three variants underwent the rheological and economic analysis. As a result, recommendations for the application of the runner system for the required amount of production have been suggested |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
