Thermal and Mechanical Properties of Novolac-Silica Hybrid Aerogels Prepared by Sol-Gel Polymerization in Solvent-Saturated Vapor Atmosphere
| Autor: | Mohamad Mehdi Seraji1, Seraji, Azadeh Seifi, Ahmad Reza Bahramian |
|---|---|
| Jazyk: | perština |
| Rok vydání: | 2015 |
| Předmět: | |
| Zdroj: | علوم و تکنولوژی پلیمر, Vol 28, Iss 2, Pp 168-161 (2015) |
| Druh dokumentu: | article |
| ISSN: | 1016-3255 2008-0883 |
| DOI: | 10.22063/jipst.2015.1248 |
| Popis: | Nowadays organic–inorganic hybrid aerogel materials have attracted increasing interests due to improved thermal and mechanical properties. In the present research, initially, novolac type phenolic resin-silica hybrid gels with different solid concentrations were synthesized using sol-gel polymerization in solvent-saturatedvapor atmosphere. The hybrid gels were dried at air atmosphere through ambient drying process. This method removed the need for costly and risky supercritical drying process. The yields of the obtained hybrid aerogels increased with less shrinkage in comparison with conventional sol-gel process. The precursor of silica phase in this study was tetraethoxysilane and inexpensive novolac resin was used as a reinforcing phase. The results of FTIR analysis confirmed the simultaneous formation of silica and novolac gels in the hybrid systems. The resultant hybrid aerogels showed a nanostructure hybrid network with high porosity (above 80%) and low density (below 0.25 g/cm3). Nonetheless, higher content of silica resulted in more shrinkage in the hybrid aerogel structure due to the tendency of the silica network to shrink more during gelation and drying process. The SEM images of samples exhibited a continuous network of interconnected colloidal particles formed during sol-gel polymerization with mean particle size of less than 100 nanometers. Si mapping analysis showed good distribution of silica phase throughout the hybrid structure. The results demonstrated improvements in insulation properties and thermal stability of novolac-silica aerogel with increasing the silica content. The results of compressive strength showed that the mechanical properties of samples declined with increasing the silica content. |
| Databáze: | Directory of Open Access Journals |
| Externí odkaz: |
|