Autor: |
Jianzhu Wang, Kunyuan Gao, Xiangyuan Xiong, Yue Zhang, Yusheng Ding, Xiaolan Wu, Shengping Wen, Hui Huang, Wu Wei, Li Rong, Zuoren Nie, Dejing Zhou |
Jazyk: |
angličtina |
Rok vydání: |
2024 |
Předmět: |
|
Zdroj: |
Journal of Materials Research and Technology, Vol 32, Iss , Pp 3573-3581 (2024) |
Druh dokumentu: |
article |
ISSN: |
2238-7854 |
DOI: |
10.1016/j.jmrt.2024.08.207 |
Popis: |
Upon 98% reduction cold-rolling, a single layer AA3003 foil material of 115 μm thick was intermediately annealed at 300–420 °C/1-8 h, and the preferred temperature and time of the intermediate annealing for the laminated AA4343/AA3003/AA4343 composite foil material were determined. All of these samples were cold rolled by 40% to 70 μm thick and finally annealed at a temperature in the range of 300–550 °C for 1–9 h. Their sagging resistance and microstructure were investigated using simulated brazing treatment, optical microscopy (OM), scanning electron microscopy (SEM) and transmission electron microscopy (TEM). For the single layer AA3003 foil, the sagging distance decreased first and then increased with increasing intermediate annealing temperature, and the lowest sagging distance corresponds to the coarsest grain in the recrystallized sample. After the final annealing for the single layer, the sagging distance decreased monotonously. For the laminated foil subjected to the final annealing, the sagging distance curves decreased first and then increased with increasing annealing temperature and time. The improvement of sagging resistance was attributed to the recovery of two types of materials during annealing process. The deterioration of the sagging resistance in the laminated foils was due to the corrosion in the brazing process, resulted from the Si diffusion from the cladding layer into the core layer. It is the coarse grains, few dislocations and minimal diffusion of Si that are crucial for improving the sagging resistance of the laminated foils. |
Databáze: |
Directory of Open Access Journals |
Externí odkaz: |
|