| Autor: |
Héctor Ortiz Rangel, Armando Salinas Rodríguez, Omar García Rincón |
| Jazyk: |
angličtina |
| Rok vydání: |
2020 |
| Předmět: |
|
| Zdroj: |
Metals, Vol 10, Iss 7, p 957 (2020) |
| Druh dokumentu: |
article |
| ISSN: |
2075-4701 |
| DOI: |
10.3390/met10070957 |
| Popis: |
The microstructure of a low Si, ultra-low-C, hot-rolled electrical steel strip is modified by annealing at T < To, the α→γ transformation temperature. This heat treatment causes the abnormal anisotropic growth of surface grains which consumes the original hot-rolled microstructure. The growth of the surface grains first takes place parallel to the rolling direction and then in a columnar form parallel to the normal direction until grains growing in opposite directions from the surfaces impinge at the center of the strip. It is shown that cold rolling and a short annealing treatment at temperatures between 700 and 800 °C leads to microstructures which result in iron energy losses that can be as much as 30% lower than those observed in the same material not subjected to the annealing prior to cold rolling. The magnitude of the reduction in energy losses depends on strip thickness and processing parameters. The major effect is observed in material annealed at 710 °C and the relative effect (with respect to material that is not annealed prior to cold rolling) decreases as the strip thickness decreases. It is shown that these effects can be attributed to the effect of the processing conditions on texture and grain size. The maximum reduction in energy losses is observed when the final microstructure consists of ferrite grains ~1.5 times larger than those obtained if the material is not annealed prior to cold rolling. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
