| Autor: |
Krolczyk Grzegorz M., Legutko Stanisław |
| Jazyk: |
angličtina |
| Rok vydání: |
2014 |
| Předmět: |
|
| Zdroj: |
Metrology and Measurement Systems, Vol 21, Iss 4, Pp 759-770 (2014) |
| Druh dokumentu: |
article |
| ISSN: |
2300-1941 |
| DOI: |
10.2478/mms-2014-0060 |
| Popis: |
The objective of the investigation was to identify surface roughness after turning with wedges of coated sintered carbide. The investigation included predicting the average surface roughness in the dry machining of Duplex Stainless Steel (DSS) and the determination of load curves together with roughness profiles for various cutting conditions. The load curves and roughness profiles for various cutting wedges and variable cutting parameters were compared. It has been shown that dry cutting leads to a decrease in friction for lubricated surfaces, providing a small initial contact area where the surface is contacted. The study has been performed within a production facility during the production of electric motor parts and deep-well pumps. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
