| Autor: |
Nazlı Akçamlı, Berk Şenyurt, Hasan Gökçe, Duygu Ağaoğulları |
| Jazyk: |
angličtina |
| Rok vydání: |
2022 |
| Předmět: |
|
| Zdroj: |
Engineering Science and Technology, an International Journal, Vol 31, Iss , Pp 101052- (2022) |
| Druh dokumentu: |
article |
| ISSN: |
2215-0986 |
| DOI: |
10.1016/j.jestch.2021.08.009 |
| Popis: |
Al-10 wt% Si matrix composites reinforced with a few-layered graphene (FLG) were fabricated via a powder metallurgical route. FLG in varying amounts (0.25, 0.5, 1, 2, and 5 wt%) was incorporated into the Al-10Si matrix via mechanical alloying (MA) for different durations in a high-energy ball mill. The mechanically alloyed (MAed) powders were consolidated by uniaxial pressing and pressureless sintering processes. The as-blended (non-MAed) and MAed powders and bulk composites were investigated comparatively in terms of microstructural, thermal, mechanical, tribological and corrosion properties. The MAed powders demonstrated refined and semi-equiaxed particle morphology with reduced crystallite size values. Additionally, the FLG/Al10Si composites exhibited advanced microstructural and mechanical properties by the contribution of MA and reinforcing particles compared to those of the as-blended and unreinforced matrix. The highest hardness and lowest wear rate values were obtained for the 4 h-MAed Al10Si-2FLG (138 HV and 6.485x10-4 mm3/N.m) and Al10Si-5FLG (178 HV and 7.456x10-4 mm3/N.m) composites. Moreover, the compressive strength of the Al-10Si matrix improved approximately by 50 and 20% via 0.5 and 2 wt% FLG addition, respectively. Also, lower corrosion resistance properties were observed for the FLG reinforced composites compared to the Al10Si matrix. |
| Databáze: |
Directory of Open Access Journals |
| Externí odkaz: |
|
