Evaluation of the Effect of Machining Technologies on the Surface Texture Analysis of Ertacetal C Polymer
| Autor: | Lucie Hrbackova, Josef Sedlak, Felicita Chromjakova, Lucie Macurova, Eva Jurickova, David Dobrocky, Filip Skerik |
|---|---|
| Rok vydání: | 2023 |
| Předmět: | |
| Zdroj: | Manufacturing Technology |
| ISSN: | 2787-9402 1213-2489 |
| DOI: | 10.21062/mft.2022.083 |
| Popis: | The surface created by machining significantly affects the service life and functional reliability of the component. As part of this study, four different chip machining technologies were evaluated on the surface texture of the polymer material Ertacetal C. The samples were processed by turning, milling, grinding and polishing technologies, 5 samples for each technology. Within the given technology, different cutting conditions were chosen to compare the effect of cutting conditions on the resulting surface roughness. The machined surfaces were comprehensively evaluated on the basis of 16 profile and surface roughness parameters due to the practical use of the tested material. Surface texture measurements were performed on a Talysurf CCI Lite device. A non-contact method using a coherence correlation interferometer was used for the measurement. The obtained data were evaluated using TalyMap Platinum software. Graphical documentation of the machined surfaces was made using an Olympus DSX500 optodigital metallographic microscope. Univerzita Tomáše Bati ve Zlíně Department of Mechanical Engineering, University of Defence in Brno [SV20-216]; Project for the Development of the Organization "DZRO VAROPS"; Tomas Bata University in Zlin [VaV-IP-RO/2022/01] |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|