Enhanced pre-treatment of cellulose pulp prior to dissolution into NaOH/ZnO

Autor: Anna Suurnäkki, Stina Grönqvist, Thaddeus Maloney, Taina Kamppuri, Marianna Vehviläinen, Tiina Liitiä
Rok vydání: 2015
Předmět:
Zdroj: Grönqvist, S, Kamppuri, T, Maloney, T, Vehviläinen, M, Liitiä, T & Suurnäkki, A 2015, ' Enhanced pre-treatment of cellulose pulp prior to dissolution into NaOH/ZnO ', Cellulose, vol. 22, no. 6, pp. 3981-3990 . https://doi.org/10.1007/s10570-015-0742-8
ISSN: 1572-882X
0969-0239
DOI: 10.1007/s10570-015-0742-8
Popis: As a result of the constantly growing demand for textile fibres interest in utilising cellulose pulps for manufacturing regenerated cellulose fibres is growing. One promising water-based process for the manufacture of regenerated cellulosic products is the Biocelsol process based on an NaOH/ZnO solvent system. The drawback of the Biocelsol process is the need for pre-treatment of the pulp, i.e. long mechanical pre-treatment (up to 5 h) followed by a 2-3-h enzymatic hydrolysis utilising a rather high amount of cellulolytic enzymes. In this work more efficient conditions to carry out the pre-treatment of cellulose pulp prior to dissolution into NaOH/ZnO are presented. Based on the results, cellulase treatment, when carried out in an extruder, can be used to effectively open up and fibrillate the fibres without completely destroying the fibre structure. The molar mass of the pulp treated enzymatically in an extruder was 14 % lower as compared to the state-of-the-art-treated cellulose. As a consequence, the alkaline solutions prepared from the pulp treated enzymatically in an extruder had clearly lower dope viscosities regarding the cellulose content than the solutions prepared from the state-of-the-art-treated pulp. This enabled increasing the cellulose content in the dope up to 7 % (w/w) without increasing the dope viscosity.
Databáze: OpenAIRE
Externí odkaz: