Surface drag analysis after Ti-6Al-4V orthogonal cutting using grid distortion
| Autor: | Pedro José Arrazola, D. Soler, G. Ortiz-de-Zarate, François Ducobu, Andres Sela, Guénaël Germain, P. Aristimuño, D. Soriano |
|---|---|
| Přispěvatelé: | Mondragon Unibertsitatea, Laboratoire Angevin de Mécanique, Procédés et InnovAtion (LAMPA), Institut National de Recherche pour l’Agriculture, l’Alimentation et l’Environnement (INRAE)-Centre National de la Recherche Scientifique (CNRS)-Arts et Métiers Sciences et Technologies, HESAM Université (HESAM)-HESAM Université (HESAM)-Institut Polytechnique de Bordeaux-Université de Bordeaux (UB), Université de Mons (UMons) |
| Rok vydání: | 2020 |
| Předmět: |
0209 industrial biotechnology
Materials science Deformation (mechanics) 02 engineering and technology Mechanics Surface finish 010501 environmental sciences 01 natural sciences [SPI.MECA.GEME]Engineering Sciences [physics]/Mechanics [physics.med-ph]/Mechanical engineering [physics.class-ph] Stress (mechanics) Mécanique: Génie mécanique [Sciences de l'ingénieur] 020901 industrial engineering & automation Machining Residual stress Distortion General Earth and Planetary Sciences Surface layer 0105 earth and related environmental sciences General Environmental Science Surface integrity |
| Zdroj: | Procedia CIRP 5th CIRP Conference on Surface Integrity, CSI 2020 5th CIRP Conference on Surface Integrity, CSI 2020, Jun 2020, E-conference, Spain. pp.372-377, ⟨10.1016/j.procir.2020.02.040⟩ |
| ISSN: | 2212-8271 |
| Popis: | International audience; Surface integrity directly affects the mechanical behavior of the workpiece, which is especially relevant on fatigue behavior. To characterize the quality of the machined surface, aspects such as material damage, roughness or residual stress are considered. Measurement of the material damage of the surface is characterized in some cases as surface drag, depth of the affected machining zone, a phenomenon which takes place due to plastic strain in the surface layer caused by machining stress which could have an influence on residual stress. Surface drag measurement done with optical microscopes has relevant uncertainty. In this paper, a methodology to measure the surface drag with lower uncertainty is proposed. The method consists of measuring the deformation of a grid as a result of the machining process. The grid was created with micromilling. The method was applied to analyze the effect of feed on the surface integrity after orthogonal cutting of Ti-6Al-4V. The depth of the affected layer was measured using a 3D optical measuring device (Alicona Infinite Focus IFG4) and compared with numerical simulations and a good agreement was achieved. In comparison with optical microscope results, it can be concluded that traditional method underestimates surface drag |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|