Study of the Feasibility of mix of Species from Sawmill Waste and Limiting for Particleboard
| Autor: | Sérgio Augusto Mello da Silva, Decio Gonçalves, Luciane Simal Alves, Maximiliano dos Anjos Azambuja, Francisco Antonio Rocco Lahr, André Luis Christoforo, Luciano Donizete Varanda |
|---|---|
| Rok vydání: | 2014 |
| Předmět: | |
| Zdroj: | Repositório Institucional da USP (Biblioteca Digital da Produção Intelectual) Universidade de São Paulo (USP) instacron:USP |
| ISSN: | 2166-4919 |
| DOI: | 10.5923/j.cmaterials.20140401.05 |
| Popis: | This study aims to determine physical properties of particleboard made of sawmill waste, as a mix of several wood species, and two adhesives: urea-formaldehyde, usually employed in industry (even with drawbacks or formaldehyde emission during pressing) and FASTBOND ® , water based resin, still poorly referenced in literature. Sixteen panels have been produced, in four experimental conditions, defined by using two adhesives and a 12 mm thick limiter (or not). Variance analysis was adopted to evaluate influence of experimental conditions on physical properties of produced panels, manufactured in nominal dimensions 350x350mm; 10% resin related to particles mass (at 5% moisture); 3.5 MPa compaction pressure, temperature 130°C, in a 10 min cycle. Tests to determine density, moisture content, swelling and water absorption were carried out based on normative parameters of ABNT NBR 14810:2006. Results have been satisfactory to panels produced with urea-formaldehyde but those manufactured with polychloroprene based resin (FASTBOND |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|