| Popis: |
Aim. To study the density and dynamic viscosity of the mixed solvents propylene glycol (PG) – macrogol 400 (M400), to calculate their excess values and excess activation parameters of viscous flow, to evaluate the features of the structure of the mixed solvents and its influence on the in vitro release of PG and M400. Materialsandmethods. The mixed solvents PG - M400 were studied over the entire concentration range at temperatures from 293.15 to 313.15 K. The density and dynamic viscosity were determined, and the excess density, excess dynamic viscosity, activation parameters of viscous flow, and excess activation parameters of viscous flow were calculated. The in vitro release of PG and M400 from the mixed solvents was studied using vertical diffusion cells. The content of PG and M400 in the receptor medium was determined by gas chromatography using validated analytical procedures. The release rate, cumulative content, percentage of released PG or M400, coefficients of correlation and coefficients of determination were calculated. Results.The isotherms of excess density and excess dynamic viscosity of the mixed solvents PG-M400 pass through a maximum. The enthalpy makes the main contribution to the free activation energy of the viscous flow. The excess free energy is positive and has small values; the values of the excess entropy and excess enthalpy are negative, and the isotherms have the minimum at PG concentrations of 70‑75mol %. The release parameters of M400 are greater in binary mixtures where the M400 structure predominates. At PG content of ~75 mol %, the release parameters for PG and M400 are identical. With the increase in PG content above 75mol %, when the PG structure predominates in the system, the release parameters of PG increase dramatically, and the release parameters of M400 decrease sharply. Conclusions.The structure of the binary system PG – M400 depends on its composition. Based on the isotherms of excess activation of viscous flow, it is possible to differentiate the areas where the structure of PG or the structure of M400 dominates, or the mixed structure of the binary solvent prevails. The in vitro release parameters for PG and M400 depend on the structure of the mixed solvents. The greatest difference in the release parameters of PG and M400 was observed in the area where the structure of PG dominates |
