New Processes for Freeze-Drying in Dual-Chamber Systems
| Autor: | Joerg Luemkemann, Hanns-Christian Mahler, Tobias Werk, Joerg Huwyler, Christina Haeuser, Imke Sonja Ludwig, Mathias Hafner |
|---|---|
| Rok vydání: | 2016 |
| Předmět: |
Pharmaceutical Science
Nanotechnology 02 engineering and technology 030226 pharmacology & pharmacy Heat capacity 03 medical and health sciences Freeze-drying Cartridge 0302 clinical medicine Drying time Technology Pharmaceutical Process engineering Biological Products Ice crystals business.industry Chemistry Syringes 021001 nanoscience & nanotechnology Freeze Drying Tray Pharmaceutical Preparations Heat transfer Sublimation (phase transition) Glass 0210 nano-technology business |
| Zdroj: | PDA Journal of Pharmaceutical Science and Technology. 70:191-207 |
| ISSN: | 1079-7440 |
| Popis: | Dual-chamber systems can offer self-administration and home care use for lyophilized biologics. Only a few products have been launched in dual-chamber systems so far-presumably due to dual-chamber systems' complex and costly drug product manufacturing process. Within this paper, two improved processes (both based on tray filling technology) for freeze-drying pharmaceuticals in dual-chamber systems are described. Challenges with regards to heat transfer were tackled by (1) performing the freeze-drying step in a needle-down orientation in combination with an aluminum block, or (2) freeze-drying the drug product "externally" in a metal cartridge with subsequent filling of the lyophilized cake into the dual-chamber system. Metal-mediated heat transfer was shown to be efficient in both cases and batch (unit-to-unit) homogeneity with regards to sublimation rate was increased. It was difficult to influence ice crystal size using different methods when in use with an aluminum block due to its heat capacity. Using such a metal carrier implies a large heat capacity leading to relatively small ice crystals. Compared to the established process, drying times were reduced by half using the new processes. The drying time was, however, longer for syringes compared to vials due to the syringe design (long and slim). The differences in drying times were less pronounced for aggressive drying cycles. The proposed processes may help to considerably decrease investment costs into dual-chamber system fill-finish equipment.Dual-chamber syringes offer self-administration and home care use for freeze-dried pharmaceuticals. Only a few products have been launched in dual-chamber syringes so far-presumably due to their complex and costly drug product manufacturing process. In this paper two improved processes for freeze-drying pharmaceuticals in dual-chamber syringes are described. The major challenge of freeze-drying is to transfer heat through a vacuum. The proposed processes cope with this challenge by (1) freeze-drying the drug product in the syringe in an orientation in which the product is closest to the heat source, or (2) freeze-drying the drug product outside the syringe in a metal tube. The latter requires filling the freeze-dried product subsequently into the dual-chamber syringe. Both processes were very efficient and promised to achieve similar freeze-drying conditions for all dual-chamber syringes within one production run. The proposed processes may help to considerably decrease investment costs into dual-chamber syringe fill-finish equipment. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|