Effect of Removal of Enamel on Rebonding Strength of Resin Composite to Enamel
Autor: | Pekka K. Vallittu, Mimmi Tolvanen, Juha Varrela, Lippo V.J. Lassila, L. Kilponen |
---|---|
Rok vydání: | 2016 |
Předmět: |
Materials science
Article Subject Surface Properties Resin composite lcsh:Medicine Dentistry 02 engineering and technology Dental bonding General Biochemistry Genetics and Molecular Biology 03 medical and health sciences 0302 clinical medicine stomatognathic system Tensile Strength Ultimate tensile strength Humans ta318 Surface layer Composite material Dental Enamel General Immunology and Microbiology Enamel paint Bond strength business.industry lcsh:R ta1183 Dental Bonding 030206 dentistry General Medicine 021001 nanoscience & nanotechnology Resin Cements Grinding stomatognathic diseases visual_art visual_art.visual_art_medium Adhesive 0210 nano-technology business Tooth Research Article |
Zdroj: | BioMed Research International BioMed Research International, Vol 2016 (2016) |
ISSN: | 2314-6141 2314-6133 |
Popis: | Objective. To examine the effect of removing the surface layer of enamel on the rebonding strength of resin composite.Methods. Teeth in four groups (n=10) were etched, a small amount of resin composite was bonded and debonded, then specimens in three groups were ground for different lengths of time (10 s, 20 s, 30 s) to remove an increasing amount of enamel, one group was left untouched. The teeth were bonded again and the bond strengths of 1st and 2nd bonding were compared and analysed against the amount of enamel loss in different groups (7 µm (±2); 12 µm (±1); 16 µm (±3)). Specimens were examined with SEM and by noncontacting optical profilometer.Results. Although results indicated higher rebonding strength with increasing enamel removal ANOVA showed low statistical differences between the groups (p>0.05). However, values between first bonding and rebonding strengths differed significantly (p<0.05) in the group that was not ground. SEM revealed that enamel-surfaces that were ground after debonding etched well, compared to the surfaces that still contained adhesive remnants.Conclusions. Removal of small amount of enamel refreshed the surface for rebonding. Rebonding strengths without grinding the surface before bonding were lower than bond strength to intact enamel. |
Databáze: | OpenAIRE |
Externí odkaz: |