Methodology for improving reliability of river discharge measurements
| Autor: | Panayotis C. Yannopoulos, Polychronis Economou, Eleni S. Bekri |
|---|---|
| Rok vydání: | 2019 |
| Předmět: |
Pollution
Environmental Engineering media_common.quotation_subject 0208 environmental biotechnology Flow (psychology) 02 engineering and technology 010501 environmental sciences Management Monitoring Policy and Law 01 natural sciences Nonlinear programming Rivers Tributary Water pollution Waste Management and Disposal Reliability (statistics) 0105 earth and related environmental sciences media_common Pollutant geography geography.geographical_feature_category Discharge Water Pollution Reproducibility of Results General Medicine 020801 environmental engineering Environmental science Water Pollutants Chemical Environmental Monitoring Marine engineering |
| Zdroj: | Journal of Environmental Management. 247:371-384 |
| ISSN: | 0301-4797 |
| DOI: | 10.1016/j.jenvman.2019.05.064 |
| Popis: | Programs to monitor water characteristics are undertaken to identify any possible water pollution of a river. To compute reliable water pollution loads, accurate river discharge and pollutant/tracer concentrations are required. When pollutants/tracers are measured with sufficient precision, the accuracy of river discharge measurements becomes the most critical parameter of the pollutant load computation, as well as the largest error source. The absence of permanent measuring equipment in many rivers is a common difficulty for the implementation of monitoring programs. Alternatively, quick measurement methods which are low in cost and reliability (e.g. floats) are often employed to get an estimate of river discharges, when there are budgetary and time restrictions. In this paper, an original technique, mainly for use in ungauged rivers, is proposed for correcting river discharge measurements which have low levels of accuracy; this in turn would correct pollutant concentrations. A nonlinear optimization problem is developed based on water volume and pollutant mass conservation principles for river balance nodes, taking into consideration non-measurable latent quantities. Parallel measurements of discharge and tracers for representative cross-sections of a river and its tributaries are required. The measurement conditions should refer to the steady-state hydraulic conditions usually prevailing in the flow under consideration. In order to test the reliability of the method, a virtual river example is built, defining the real values of water characteristics and generating measurement sets via Monte-Carlo simulations combining random and systematic errors. For more than 92% of the generated measurement sets, the proposed technique results in a successful and acceptable correction for the total of the measured cross-sections. Finally, the method is applied to a real river and the measurements are corrected successfully. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect