A Study on the Evaluation of Flow Distribution Evenness in Parallel-Arrayed-Type Low-Pressure Membrane Module Piping
| Autor: | Sukmin Yoon, Woo-Chang Jeong, Yongwook Jeong, No-Suk Park |
|---|---|
| Rok vydání: | 2021 |
| Předmět: |
Materials science
education Flow (psychology) Filtration and Separation TP1-1185 computational fluid dynamics Article Reynolds number law.invention symbols.namesake Chemical engineering Ultrasonic flow meter law Header Chemical Engineering (miscellaneous) ultrasonic flow meter Piping Chemical technology Process Chemistry and Technology Laminar flow Mechanics manifold pipe structure Volumetric flow rate symbols TP155-156 flow distribution evenness Manifold (fluid mechanics) |
| Zdroj: | Membranes Membranes, Vol 11, Iss 751, p 751 (2021) Volume 11 Issue 10 |
| ISSN: | 2077-0375 |
| DOI: | 10.3390/membranes11100751 |
| Popis: | The objectives of this study were to measure the flow rate distribution from a header pipe to each module installed in parallel for a water treatment membrane filtration process in operation and to investigate the reason for an uneven distribution of the flow rate via the CFD technique. In addition, this study attempted to propose the ratio of the branch pipe to the header pipe required to equalize the flow distribution for the same membrane filtration process. Finally, the relationship between the Reynolds number in the header pipe and the degree of the manifold flow distribution evenness was investigated. Mobile ultrasonic flow meter was used to measure the flow rate flowing from the membrane module pipe to each module, and the CFD technique was used to verify this. From the results of the actual measurement using ultrasonic flow meter and CFD simulation, it was confirmed that the outflow flow rate from the branch pipe located at the end of the header pipe was three times higher than that of the branch pipe near the inlet. The reason was that the differential pressure generated between each membrane module was higher toward the end of the header pipe. When the ratio of the sum of the cross-sectional area of the branch pipe and the cross-sectional area of the header pipe was reduced by about 30 times, it was confirmed that the flow rate flowing from each branch pipe to the membrane module was almost equal. Also, if the flow in the header pipe is transitional or laminar (Reynolds No. is approximately 4000 or less), the flow rate flowing from each branch pipe to the membrane module can be more even. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|