Influence of Treated Distillate Aromatic Extract (TDAE) Content and Addition Time on Rubber-Filler Interactions in Silica Filled SBR/BR Blends
| Autor: | Katja Oßwald, Katrin Reincke, Selin Sökmen, S. Ilisch |
|---|---|
| Rok vydání: | 2021 |
| Předmět: |
010407 polymers
Materials science Polymers and Plastics silica SBR BR rubber–filler interactions viscoelastic properties mechanical properties Payne effect Young's modulus 02 engineering and technology 01 natural sciences Article lcsh:QD241-441 symbols.namesake lcsh:Organic chemistry Natural rubber Ultimate tensile strength Shore durometer Composite material Tensile testing Plasticizer General Chemistry Dynamic mechanical analysis 021001 nanoscience & nanotechnology 0104 chemical sciences visual_art visual_art.visual_art_medium symbols 0210 nano-technology |
| Zdroj: | Polymers Polymers; Volume 13; Issue 5; Pages: 698 Polymers, Vol 13, Iss 698, p 698 (2021) |
| ISSN: | 2073-4360 |
| Popis: | High compatibility and good rubber–filler interactions are required in order to obtain high quality products. Rubber–filler and filler–filler interactions can be influenced by various material factors, such as the presence of processing aids. Although different processing aids, especially the plasticizers, and their effects on compatibility have been investigated in the literature, their influence on rubber–filler interactions in highly active filler reinforced mixtures is not explicit and has not been investigated in depth. For this purpose, the influence of treated distillate aromatic extract (TDAE) oil content and its addition time on interactions between silica and rubber chains were investigated in this study. Rubber–filler and filler–filler interactions of uncured and cured silica-filled SBR/BR blends were characterized by using rubber layer L concept and dynamic mechanical analysis, whereas mechanical properties were studied by tensile test and Shore A hardness. Five parts per hundred rubber (phr) TDAE addition at 0, 1.5, and 3 min of mixing were characterized to investigate the influence of TDAE addition time on rubber–filler interactions. It was observed that addition time of TDAE can influence the development of bounded rubber structure and the interfacial interactions, especially at short time of mixing, less than 5 min. Oil addition with silica at 1.5 min of mixing resulted in fast rubber layer development and a small reduction in storage shear modulus of uncured blends. The influence of oil content on rubber–filler and filler–filler interactions were investigated for the binary blends without oil, with 5 and 20 phr TDAE content. The addition of 5 phr oil resulted in a slight increase in rubber layer and 0.05 MPa reduction in Payne effect of uncured blends. The storage tensile modulus of vulcanizates at small strains decreased from 13.97 to 8.28 MPa after oil addition. Twenty parts per hundred rubber (phr) oil addition to binary blends caused rubber layer L to decrease from 0.45 to 0.42. The storage tensile modulus of the vulcanizates and its reduction with higher amplitudes were incontrovertibly high among the vulcanizates with lower oil content, which were 13.57 and 4.49 MPa, respectively. When any consequential change in mechanical properties of styrene–butadiene rubber (SBR)/butadiene rubber (BR) blends could not be observed at different TDAE addition time, increasing amount of oil in blends enhanced elongation at break, and decreased Shore A hardness and tensile strength. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|