In situ fabrication of conducting polymer composite film as a chemical resistive CO2 gas sensor
Autor: | Yi-Huan Lee, Chia Yu Lin, Chien-Chung Shih, Chi-Ju Chiang, Kang-Ting Tsai, Hung-Wei Lin, Yao-Yi Cheng, Huai-An Jeng, Kuo-Chuan Ho, Chi-An Dai, Yu-Hsuan Weng, Yi-Lung Yang |
---|---|
Rok vydání: | 2013 |
Předmět: |
Conductive polymer
Resistive touchscreen Fabrication Materials science Composite number Conductivity Condensed Matter Physics Atomic and Molecular Physics and Optics Surfaces Coatings and Films Electronic Optical and Magnetic Materials PEDOT:PSS Chemical engineering Electrical and Electronic Engineering In situ polymerization Composite material Layer (electronics) |
Zdroj: | Microelectronic Engineering. 111:409-415 |
ISSN: | 0167-9317 |
Popis: | In this study, an easy to fabricate and low-cost, resistive-type CO"2 gas sensor made of poly(3,4-ethylenedioxythiophene) (PEDOT) and branched polyethylenimine (BPEI) layers was fabricated on an interdigitated electrode. The PEDOT film was made by in situ polymerization and the BPEI layer was subsequently drop-coated on top of the PEDOT film. Upon exposure to 1000ppm CO"2 at 95% relatively humidity (RH) of the BPEI-PEDOT composite sensor, the synergistic effect of BPEI on CO"2 sensing was subsequently investigated. The sensors showed no response (i.e. % of conductivity increase) if the sensor film was only made of a PEDOT layer without any BPEI. However, the response increased significantly to a value of 3.25% upon the addition of a layer of BPEI. The sensors also showed no obvious decay in the sensing response during repeated usages, providing the reusability of the technique for CO"2 detection. As for sensor's selectivity, the sensors showed higher response for CO"2 than for O"2. Originally, the sensor showed a long recovery time of nearly 1h. However, the long recovery time can be significantly shortened to approximately 10min by heating the sensors at higher temperature for CO"2 desorption. Thus, this easy and inexpensive fabrication process demonstrated that the sensor might have characteristics sufficient for real-world CO"2 detection. |
Databáze: | OpenAIRE |
Externí odkaz: |