Characteristics of carbon dioxide sorption in coal and gas shale – The effect of particle size
| Autor: | Miguel A. Gonzalez Gonzalez, Marcin Lutyński |
|---|---|
| Rok vydání: | 2016 |
| Předmět: |
Materials science
business.industry 020209 energy technology industry and agriculture Energy Engineering and Power Technology Langmuir adsorption model Mineralogy Sorption 02 engineering and technology Geotechnical Engineering and Engineering Geology complex mixtures symbols.namesake Fuel Technology Inertinite Adsorption 020401 chemical engineering 0202 electrical engineering electronic engineering information engineering symbols Coal Particle size 0204 chemical engineering business Clay minerals Oil shale |
| Zdroj: | Journal of Natural Gas Science and Engineering. 28:558-565 |
| ISSN: | 1875-5100 |
| DOI: | 10.1016/j.jngse.2015.12.037 |
| Popis: | Gas retention mechanisms in shales are to some extent similar to that of coal. The gas is adsorbed in organic matter (mostly organic carbon) and clay minerals whereas transport of gas occurs in fractures. In the study two materials were analyzed– coal from the Upper Silesia Coal Basin and shale sample from Baltic Basin. The coal selected for experiments was a bituminous steam coal with 3.8%wt ash content. The shale sample was characterized by rather low TOC (1.1%) but high clay minerals content. The purpose of the study was to compare the high pressure CO2 sorption characteristics of coal and gas shale and relate it to the particle size of samples subjected to tests. The size of the adsorbate has an impact on the sorption equilibrium time and reaching thermodynamic equilibrium occurs much faster in fine grained fractions. On the contrary, the particle size must reflect natural in-situ conditions and accessibility to the nano- and micropores where sorption occurs. In this study both sorbents were crushed and sieved into three particle size fractions and the CO2 sorption was measured. The measurements were performed at the constant temperature of 55 °C and up to the pressure of 15–16 MPa. To model the sorption behavior a three parameter Langmuir model was fitted to experimental values. Results of the sorption tests show that the particle size of the sorbent has an impact on the obtained sorption isotherm. In case of coal, the difference in the sorption capacity could be related to the ash and inertinite content which are passing to fine particle size ( |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect