Conditions for obtaining positronium Bose–Einstein condensation in a micron-sized cavity

Autor: Marcus X. Asaro, Steven Herrera, Melina Fuentes-Garcia, Gabriel G. Cecchini, Erick E. Membreno, Rod G. Greaves, Allen P. Mills
Rok vydání: 2022
Předmět:
Zdroj: The European Physical Journal D. 76
ISSN: 1434-6079
1434-6060
DOI: 10.1140/epjd/s10053-022-00427-1
Popis: Abstract The quest for making a triplet positronium (Ps) Bose–Einstein condensate confined in a micron-sized cavity in a material such as porous silica faces at least three interrelated problems: (1) About $$10^7$$ 10 7 spin polarized Ps atoms must be injected into a small cavity within a porous solid material without vaporizing it. (2) It is known that Ps atoms confined in 30–100 nm diameter cavities in porous silica do not remain in the gas phase, but become stuck to the cavity walls at room temperature (Cooper et al., Phys. Rev. B 97:205302, 2018). (3) Cooling a gas of Ps atoms to cryogenic temperatures by energy exchange with the walls would be a very slow process (Saito and Hyodo, in: Surko, Gianturco (eds) New Directions in Antimatter Chemistry and Physics, Springer Dordrecht, Netherlands, 2001) because of the relatively low collision rate with the walls and the large mismatch between the masses of the Ps and the wall atoms. A possible solution of these difficulties is presented, based on cooling the implanted positrons in an isotopically pure diamond single crystal target, subsequent saturating of the wall Ps coverage so that a substantial portion of the Ps will be in the gaseous state, and thermalizing the gas-phase Ps via collisions with the low effective mass wall Ps. A design process for the target material is outlined as well, including preliminary results in porous cavity fabrication using focused ion beam milling. Graphical abstract
Databáze: OpenAIRE
Externí odkaz: